Need help with Tein spring install...

[Smokey159]

I bought a set of used Tein S-Tech springs.

I need pics of them installed from the underside.

I need to find out which end is up, and I need to know what the instructions said for the recommended cut is on the bumpstops.

I looked on tein's website, but the install instructions page comes up with "page not found".

Thanks in advance.

[largeorangefont]

I bought a set of used Tein S-Tech springs.

I need pics of them installed from the underside.

I need to find out which end is up, and I need to know what the instructions said for the recommended cut is on the bumpstops.

I looked on tein's website, but the install instructions page comes up with "page not found".

Thanks in advance.


Flat side of the springs go to the top,

Cut the bumpstops just below the plastic piece in the center, which is cutting off about an inch.

[Smokey159]

OK, I got the official word from Tein on this issue.

The S-Techs require that 1.4 inches be cut off the end using their "A" cut method. They have 4 different ways to cut bumpstops, the different methods can be found in the tech section of their website.

[mojoyaris]

Have fun Modding your car. And yes. I think you really are missing your STI.......

[nerd_vitZ]

i just looked at the words on the spring itself. up = up?

[Malaya1221]

^ if you could read the words from the spring then you're installing it correctly!

[thewifesyaris]

A pic of mine from a while ago.
http://img26.picoodle.com/img/img26/3/11/4/f_DSCF2349m_7dd6636.jpg