Treyz
11-03-2008, 09:40 PM
Been meaning to post this up, but never took the time to take pics.
Basically I wanted to make the trunk a little bit more worth looking at so I picked up a shallow Kenwood 12" sub so I could keep the donut and ripped out part of my old system in another car that was sitting doing nothing. Eventually I want to pick up a new amp (this one is 15 years old or so) and change it up a bit.
I mainly did it for the Lawrence Toyota show which I took home 1st for Yaris Hatch for those that didn't know.
Enjoy!
http://i6.photobucket.com/albums/y203/Treyz/DSC01553.jpg
http://i6.photobucket.com/albums/y203/Treyz/DSC01554.jpg
http://i6.photobucket.com/albums/y203/Treyz/DSC01555.jpg
Took about 3 days to do (with pulling an all nighter the day of show) since the Dremel took a shit on me. Took it old school afterwards and used files to hand craft the curves lol.
I gotta say, not bad for my first custom setup rather than the traditional pre made box.
The bottom is wrapped in a light grey vinyl fabric and the amp and cap covers in regular tunk fabric. All thats missing are neons on the inside of those covers. Also, the covers are velcroed down so I can easily get to the wiring if needed.
I'd like to possibly etch something onto the plexi, but don't know if it'll be worth it if I'm gonna change it up again possibly.
Basically I wanted to make the trunk a little bit more worth looking at so I picked up a shallow Kenwood 12" sub so I could keep the donut and ripped out part of my old system in another car that was sitting doing nothing. Eventually I want to pick up a new amp (this one is 15 years old or so) and change it up a bit.
I mainly did it for the Lawrence Toyota show which I took home 1st for Yaris Hatch for those that didn't know.
Enjoy!
http://i6.photobucket.com/albums/y203/Treyz/DSC01553.jpg
http://i6.photobucket.com/albums/y203/Treyz/DSC01554.jpg
http://i6.photobucket.com/albums/y203/Treyz/DSC01555.jpg
Took about 3 days to do (with pulling an all nighter the day of show) since the Dremel took a shit on me. Took it old school afterwards and used files to hand craft the curves lol.
I gotta say, not bad for my first custom setup rather than the traditional pre made box.
The bottom is wrapped in a light grey vinyl fabric and the amp and cap covers in regular tunk fabric. All thats missing are neons on the inside of those covers. Also, the covers are velcroed down so I can easily get to the wiring if needed.
I'd like to possibly etch something onto the plexi, but don't know if it'll be worth it if I'm gonna change it up again possibly.