Resetting a Scan Guage II?

[CKaelin]

I loaned my scan guage to a friend with a tacoma. I have not been able to get it recalibrated to my Yaris since I've gotten it back. I think I may have furthered the problem after filling up. I adjusted the % to 100 asssuming that meant the tnak was 100% full. Any advice on how to rest the scan guage?

Thanks in advance!

[Bob_VT]

You have to go through the setup and remember when you FILL the tank you shoud have to do that 2x. It has a flash memory so there is no real reset.... just new setup.

The manual is available on line.

Remember the Yaris Fuel Cut Off should be set to 21

[CKaelin]

You have to go through the setup and remember when you FILL the tank you shoud have to do that 2x. It has a flash memory so there is no real reset.... just new setup.

The manual is available on line.

Remember the Yaris Fuel Cut Off should be set to 21

I had done the set up: tank size, fuel, engine size etc.. I had not set the Fuel Cut off it was at 0. When I fill up do I have to adjust the percentage shown or should I leave that alone?

Thanks Bob!

[Bob_VT]

Leave the percentage alone and remember to run the tank down about 3/4 after 2 fill ups it should be accurate again.

[CKaelin]

Well I found the magic "reset to defaults" reset button that noone thought exists. Not sure how exactly but I did. Then followed the set up. It's working great once again.. =) I will "refill" today aswell..