getting my yaris faster

[Tom W]

So far I have ordered a k an n typhoon induction kit and are looking for ways to get it faster I am thinking chipping it but don’t no how to go about it. I am trying to get the back seats out of my 05 reg yaris t sport but not sure how to get them out can you help me and if you have any other ideas about how to get it faster it would be appreciated. :burnrubber::bow:

[ztrack157]

Searching is your friend. Use it Shakespeare.

[thebarber]

Searching is your friend. Use it Shakespeare.

way to welcome new people, ass

id suggest an exhaust for the next move in the make-the-car-faster spectrum...

[Doc Zaius]

... I am trying to get the back seats out of my 05 reg yaris t sport but not sure how to get them out can you help me ...

You should buy a set of female Torx sockets. You can pick these up at AutoZone and the like. I think you need E10 (I'm going from memory... somebody correct me if I'm wrong). There are 7 bolts on the larger side of the 60/40 split. I think there are 5 on the other side? I dunno. Start by popping off the little covers in the rear passenger footwell (just behind the rear mats), and undo those, then lift up the seats, and you'll find the other on the rail holding it to the car.

Good luck, and welcome aboard! :biggrin:

[CASTREX]

OK, you have a 2005 T-Sport right?

Are you from the UK?

If this is correct, you should be looking at Envyperformance.com for any part for your car.:wink:

[Doc Zaius]

Oh dang... an '05. Previous generation. Never mind. Almost all of the English-speaking parts of this website are dedicated to the 2006+ Yaris (it was the "Echo" before that in North America).

[Tom W]

yea im from the uk and thanks for the help ill keep you posted with how its goin :burnrubber:

[Tom W]

Just got a de-cat from Envyperformance.com it was a bit expensive tho £250!! And i worked out how to get the back seats out. Just waiting to get it chiped :burnrubber:

[cleong]

An engine chip isn't a magic bullet - I suggest you get your I/H/E modifications done up before you use an engine piggyback to optimize the performance.

To my knowledge, you can buy NCP13 headers, but from what I know, Vios NCP42 hraders will work too.