DIY high flow/SRI?

[whiteghetto]

In reference to this post
http://www.yarisworld.com/forums/showthread.php?t=4392

is this feasible?
I am cheap/poor/whatever...

would a high flow filter
remove silencer tube and a few well placed holes make a difference?

anyone tried it have a comment?

[mikenacarato]

here ya go

http://www.yarisworld.com/forums/showthread.php?t=13476 :)

it comes with the high flow filter and the works already done!

[33OH]

I've never had the holes in my airbox, but just with a Simota high-flow filter I did notice a small difference in pep and in MPG's. :wink:

[whiteghetto]

does it actually work though?
risks? real benefits?

[mikenacarato]

ya it works. i felt some low end gain on the butt dyno, plus it sounds awesome! you wont get any CELs and if you drive it nice and easy you should gain some mpg from better flow. but, if your like me adn you love the sound then i think i probably lost mpg from stomping on it everywhere! lol

[whiteghetto]

ROFL, thanks man. I will have to do this then. I love getting something for free/cheap :)

[whiteghetto]

how hard is that plastic to cut?
could I reach in and cut without removing the airbox?

[jonismyname]

i popped about 12 1/2inch holes in my airbox... sounds good, better response, intake air temp went up a bit though (scangauge)... im gonig to try some ducting from fog lamp opening to the driver side of the airbox, try and cool things down a bit...

[jonismyname]

i'd do it again, but at 115 shipped the simota from kargoboy sure does sound nice...

[whiteghetto]

i'd do it again, but at 115 shipped the simota from kargoboy sure does sound nice...


it does sound very nice
but right now photography and home network over intake :(

[mikenacarato]

thats why you should buy mine. the works done and its got a high flow filter in it already! hehe :)