toad
06-06-2009, 12:49 PM
ok. i'm getting ready to do the DREADED df210 install this tuesday. the reason i've picked tuesday is because i've got somewhere to be on monday and i have the rest of the week off(vacation) with no other plans:redface: i've been reading the DIY on the forum and even reading all the 'help me' threads on the matter for information. i've collected the following parts for install:
17mm OFFSET box wrench
6mm allen key
jack stands
various metric sockets/wrench
small hacksaw(for cutting bump stop)
df210 springs
tanabe front strut tower(i might as well install since the wiper cowl will be off and car will be on jack stands)
i haven't rented the spring compressor yet because i want to wait until i actually have the front struts off the vehicle(which seems to be the 'make or break' moment of the install)! any words of advice from anyone who recently performed the install? no, i can't afford an impact wrench so i guess i might need some type of lead/steel pipe for help turning the wrench? wish me luck!:smile:
17mm OFFSET box wrench
6mm allen key
jack stands
various metric sockets/wrench
small hacksaw(for cutting bump stop)
df210 springs
tanabe front strut tower(i might as well install since the wiper cowl will be off and car will be on jack stands)
i haven't rented the spring compressor yet because i want to wait until i actually have the front struts off the vehicle(which seems to be the 'make or break' moment of the install)! any words of advice from anyone who recently performed the install? no, i can't afford an impact wrench so i guess i might need some type of lead/steel pipe for help turning the wrench? wish me luck!:smile: