Rear camber

[BrazdonW]

are there any DIY's on how to use the EZ shim on our car?

[ozmdd]

they've probably been pulled and put on that other forum, since sharing DIY's is apparently not as cool as it used to be. IMHO, its probably best to let the alignment guy put them on, since they are the only ones who can measure the results anyway. At NTB, that is part of the cost for alignment, so they're used to installing those when needed. My guy insisted that I let him do it so the wrong tabs didn't get popped out. As much as we expect our suspension to be symmetrical from the factory, it often isnt.

[BrazdonW]

its def not symmetrical
i have a ton of tools here in our garage
i would not be surprised if we had the tool to measure it
at very least id still like to know what the procedure is