DIY Needed removal of entire e brake boot cover if it is possible?

[YarisSedan]

I am looking to neffy wrap the handle of my e brake. But rather than start trying to cover up my interior and spray it with ahesive id like to pull it off do it in my garage let it dry and put it back on the car after its done.

Does anyone know if its possible to pull it off or its glued in place?

[1NZYaris1]

You talking about the rubber boot , if so yes it just pulls off .
run your fingers underneath it, it is split underneath :thumbsup:
stick in fingers and pull apart carefully :biggrin:

[YarisSedan]

You talking about the rubber boot , if so yes it just pulls off .
run your fingers underneath it, it is split underneath :thumbsup:
stick in fingers and pull apart carefully :biggrin:

Im talking about the boot and the plastic handle.

[JumpmanYaris]

thats easy u dont need someone to tell u how to do that its common sence brother but just to give u a start it starts from all the way back check for 2 bolts I dont remeber if the yaris has them

[YarisSedan]

thats easy u dont need someone to tell u how to do that its common sence brother but just to give u a start it starts from all the way back check for 2 bolts I dont remeber if the yaris has them

Well i didnt feel like removing the exterior panel just to check if someone knew already if it came out. If the plastic housing is molded or glued to the metal e brake handle i figured someone might know. I tried to pull on it and twist it so figured it might be. Unless someone knows otherwise.

[1NZYaris1]

Pics from when i did ssk and h/boot
as for the plastic hand brake peice itself, i have never tried to take it off :thumbsup: