Yaris Cat-Back exhaust

[Teruyume]

i've been really searching up on Cat-backs for yaris.... but i can find non....

and i know why now... i figured that the catalytic converter and the mid pipe is in one piece.... so that's why we only get axle-back.....:frown:

and i had searched up on xA and xB catbacks they all require chopping the mid-pipe.... that really makes it gay.... if u want to put it back to stock.....

i have couple PDFs....to prove this check it out..............

BIG SIGH to whoever looking for catbacks................. :frown: which including me >_<

[bigsky2]

Isn't the Canadian exhaust upgrade (Borla) a cat-back exhaust system?
I remember speaking to a parts rep and he sad it was a cat-back system.
Maybe he's mistaken?

riceboy, can you comment?

[Teruyume]

this is the mid pipe, behind the cat is the resinator and stuff in one piece.... there's no way for bolt on cat-back exhaust:frown:

[bigsky2]

Crap, I just noticed that too.

So the Borla exhaust is NOT bolt on cat-back I presume?

[Teruyume]

yup it's a bolt on tail piece

[bigsky2]

Get the TRD JDM one!

I just got mine... Pretty light weight

[dngz]

cant u get a custom cat-back?

[johnnyfive]

cant u get a custom cat-back?

sure, they will just cut, and weld it in, or >< clamp it in ;)

[eTiMaGo]

might not someone make a full exhaust piping replacement with high-flow catalysers at some point in the future?

[riceboy]

mine is an axle back... that's why megan put off plans for a midpipe..lots of work....

[Teruyume]

if the mid pipe comes with highflow cat will be awsome ^_____^

but i guess the full catback will be looking at $1000+

[Katana]

The 1.3lt engine exhaust system is totally different...

[Russelt3hPirate]

every one I've seen so far for the USDM MY07 Liftback is an axle back.

[ChinoCharles]

Don't forget there is that service bulletin... if you're under warranty and you go to a dealer and complain about a sulfur odor outside of your car, they will replace your midpipe with a higher-flowing version. Not exactly my idea of a performance gain, but now you know...


http://www.yarisworld.com/forums/showthread.php?t=1296&highlight=sulfur

[Snake]

go to meineke and make them bend you one from scratch should cost less minimal and they can make it 2.25"

[BulletProofAuto]

best exhaust you would be able to make would just be a straight pipe all the way back eliminating the cat...i am not aware of any companies in japan that are even doing this but i can look further into it. i have not seen any mid pipe options though, it'll probably have to come domestically since japan is pretty eco friendly when it comes to exhausts.

[Snake]

do not take the cat off on this car if its NA, I did it on my scion xB and the car ran like shit* even with the check engine light not on
buy a high flow cat from summit racing and it will do the trick
they range from $45-$160 depending on the quality you want

[eco]

Are you sure a mid pipe from an XB will fit a Yaris sedan/HB