H3LlIoN
01-26-2011, 01:35 AM
It's spring cleaning time...I have too much stuff. These throttle bodies are not USDM yaris compliant out of the box.
The 1zz tb is cable driven...big as hell, and *would* be the equivalent swap for an xB motor, except a flange or adapter would be needed to mate it to an existing 1nz DBC intake mani. It's huge though, and should flow well. As is...unsure if sensors work or not. $100 shipped ContUSA - OBO
http://i52.tinypic.com/29wn2gg.jpg
http://i56.tinypic.com/o922wz.jpg
#2 is a ported and polished Bullfrog throttle body by Gude. He charges like $250 for these, IIRC. Basically, what's done is that it's taken apart, bored out...larger butterfly is machined, reassembled. This is a direct bolt on for the 1nz DBC intake mani, whether it be xB or *otherworldly* yaris/echo/vitz/etc. I know there is a lot of attention concerning Gude lately and the extreme turbo stuff a member here had built, but the truth is my car runs great and I no longer have top end drop off like I did with factory equipment. The only reason I have this is because I sent him an xB TB as a core with the head thinking that I would be able to swap to DBC after the fact. Basically, I hadn't done any research. Tisk tisk. It's doing me no good, so it's up. $150 shipped ContUSA - obo
The red in the pics is the gasket stuff Gude uses to test his butterflys...it will all be gone by the time you get the TB.
http://i55.tinypic.com/2prv1g1.jpg
http://i56.tinypic.com/jr3502.jpg
http://i54.tinypic.com/2uj46ly.jpg
The 1zz tb is cable driven...big as hell, and *would* be the equivalent swap for an xB motor, except a flange or adapter would be needed to mate it to an existing 1nz DBC intake mani. It's huge though, and should flow well. As is...unsure if sensors work or not. $100 shipped ContUSA - OBO
http://i52.tinypic.com/29wn2gg.jpg
http://i56.tinypic.com/o922wz.jpg
#2 is a ported and polished Bullfrog throttle body by Gude. He charges like $250 for these, IIRC. Basically, what's done is that it's taken apart, bored out...larger butterfly is machined, reassembled. This is a direct bolt on for the 1nz DBC intake mani, whether it be xB or *otherworldly* yaris/echo/vitz/etc. I know there is a lot of attention concerning Gude lately and the extreme turbo stuff a member here had built, but the truth is my car runs great and I no longer have top end drop off like I did with factory equipment. The only reason I have this is because I sent him an xB TB as a core with the head thinking that I would be able to swap to DBC after the fact. Basically, I hadn't done any research. Tisk tisk. It's doing me no good, so it's up. $150 shipped ContUSA - obo
The red in the pics is the gasket stuff Gude uses to test his butterflys...it will all be gone by the time you get the TB.
http://i55.tinypic.com/2prv1g1.jpg
http://i56.tinypic.com/jr3502.jpg
http://i54.tinypic.com/2uj46ly.jpg