Log in

View Full Version : Will these fit?

Shawn D
08-09-2011, 11:29 AM
Hey does anyone know if the 14" Honda HX wheels will fit on our cars without issues. I would assume they would but Just thought I'd ask to see if anyone is already running them.
thebarber
08-10-2011, 12:06 AM
will depend on spoke design and offset....have some pics?
kimona
08-10-2011, 01:12 AM
I presume this is the Honda wheel you're talking about. I don't recall seeing any yarisworld member with these wheels. Unless someone can give you a definitive answer, I guess you'll just have to test fit.
weedtank
08-10-2011, 05:16 AM
Had these on my old civic. They are 4x100 and about 45 offset. Should fit on the yaris..
kimona
08-10-2011, 08:42 AM
Had these on my old civic. They are 4x100 and about 45 offset. Should fit on the yaris..

The bolt pattern and offset are fine, but with some 13's and 14's there may be an issue with brake caliper clearance.
33OH
08-10-2011, 11:08 AM
May have to run small (5mm) spacers, but I'd say there's a very good possibility they'll fit.

I ran 14" CRX SI wheels with 5mm spacers and they cleared.
CrankyOldMan
08-10-2011, 12:48 PM
The bolt pattern and offset are fine, but with some 13's and 14's there may be an issue with brake caliper clearance.

What about the hub ring diameter? Isn't that part of the load bearing?
WeeYari
08-10-2011, 12:55 PM
What about the hub ring diameter? Isn't that part of the load bearing?

So long as the hub bore of the wheel matches or exceeds the Yaris hub diameter (which these wheels do), OP is fine. Just like any other aftermarket wheel, hub rings will be required to fill the gap.

I believe these wheels are manfactured by Enkei, and I've not heard of any issue with 14" Enkei wheels to clearing the calipers. This does however remain as the one and only potential fitment issue.
CTScott
08-10-2011, 01:06 PM
The 4x100 Hondas are 56.1mm for the center bore (same as Mini Cooper) versus the 54.1mm for the Yaris. It is really hard to find hubcentric rings for that small of a difference, but with the proper tapered lug nuts you can run lugcentric.

This is a great reference for bore and lug pattern:
http://adaptitusa.com/referencebook.htm

And, this is the only place where I have seen off the shelf 54.1 to 56.1 hubcentric rings:
http://www.hubcentric-rings.com/size-56.1-54.1/
thebarber
08-11-2011, 11:39 PM
at a 45 offset...id wager you'll need 5mm spacers to clear the calipers