FS: 1nzfe forged

[Radou]

hello! lately I buy a house which brings me to sell my engine. it breaks my heart to have to sell it but i dont have the choice. this is what the whole includes
CAN BE SOLD AS A PART OUT IF YOU INTERESTED PM ME
1nzfe at original size 75mm only honed
cp pistons with 9.0:1
Brian crower rods
toga main and rod bearing
Perrin fuel rail
custum t25 manifold
garret t25 from a s13 freshly rebuilded
vibrant oil feed line -4 an
vibrant valve covert vent
downpipe flange with v band clamp
felpro head stud
brand new water pump
brand new timing chain
brand new gasket (all)
brand new Thermostat
i have 3 mandrel bend for the exhaust
1x uj bend
1x 45 deg bend
1x 90 deg bend
compressor inlet flange
compressor outlet flange
glowshift boost gauge

posibility to sell the aem fic with this
some pictures !!!
http://s10.postimage.org/53q2omflx/294928_10151005209764309_919489597_n.jpg (http://postimage.org/image/53q2omflx/)

http://s10.postimage.org/4fh85ogw5/crower_billet_rods.jpg (http://postimage.org/image/4fh85ogw5/)

http://s10.postimage.org/nluf8uxdx/ptp_eng_200.jpg (http://postimage.org/image/nluf8uxdx/)

http://s10.postimage.org/kg9tinerp/SC7446_2.jpg (http://postimage.org/image/kg9tinerp/)

http://s10.postimage.org/tcklml5dx/toga_bearings.jpg (http://postimage.org/image/tcklml5dx/)

like not having to do a part out but if i can sell all of my parts i will do one

my starting price 3000$ neg
all you'll have to buy is a clutch injectors and piping

i just want to sell this kit for buying me a set of coilover for lowering and pass to another project (my house)
any good offer will be accepted

i'm living in quebec canada posibility to ship via morneau transport or dicom and if i need to part out i gonna use another shipping companie

P.s. sorry for my bad english

[BLITZEN]

mmmm... interressant !

Combien de hp tu target avec ce setup la ?

Et la base est-tu closed deck ou open ?

thx

[1.5]

Ugh I wish I could swap this thing in my sedan... I need a raise GLWS

[cali yaris]

I might bring this down here for someone that wants it.

What shop did the honing work and assembly?

This motor is built but never fired up?

[fnkngrv]

To me it is a great start...just wish that it was sleeved even though I know that it overkill for most folks. GLWS.

[Radou]

never fired up and the engine have been honed with a simple honing machine here in matane

[Radou]

not sleeved conservatory setup for 200 whp goal

[Radou]

can be sold as a part out

[Radou]

IN SALE AGAIN REASONABLE OFFER ARE ACCEPTED !!!