first gen yaris header

[fase4]

Hey, I'm looking to get a header from DC sports. But my yaris is a 1st gen TS 05 and there are two models of they: SHC4401 and THC4407.

They say the shc is for echo model 00-05 and the thc for yaris 07-

What you do say? Maybe I should go over the shc?

[cali yaris]

Are you ordering it from us? :smile:

Do you have the 1NZ-FE motor?
Is your pulley one or two-ribbed?

[fase4]

I don't know yet. Maybe yes :D

Yes, it is a 1nz-fe. How can I know or see if is one or two-ribbed pulley? What does mean?

[cali yaris]

Look at your crank pulley -- is it driving one or two belts?

The Echo/xB/xA have two-belt pulleys, the Yaris (2nd gen) has a single belt pulley.

[fase4]

It's driving 2 belts, one goes for the right (alternator, A/C...) And the other for the left (vane pump I think)

[cali yaris]

ok that's first gen -- echo, xB, xA. I probably have one in stock. Just installed one on my son's car too, sounds great.

[fase4]

Learning something new, great! Thanx!

But that means I cannot install MI pulley? Nor NST?

[fase4]

hey guys... I had a look to the stock header that is in my yaris and look a o2 sensor is in there, look back at the dc headers and the shc doesn't have a place to put it and the thc does.

my header looks very very similar to this http://photo.qip.ru/users/tolmach/96608749/129640829/
from TOLMACH even in the retainer fron the left

So I should go over for the header thc for yaris and no the echo/xB/xA?

[cali yaris]

The xB/xA header does not have an O2 bung, the Yaris one does. (THC vs. SHC part numbers). Tolmach's has the bung. Header is THC4407

[fase4]

So the header is the THC. What about the fitment? it will going all matched?