Flat Tire

[sambo42xa]

Ok, seems like its been dead in here for awhile, so I'll start a new thread.
Had a flat the other day (car sat for 3.5 days) before I left for work. Put air in it and managed to get to work later. At work I checked it out and found on the inside groove a small sheet metal or wood screw. Now, I can put a plug in it myself BUT I'm not sure I want to. Why.....you ask? The screw is small in diameter and I don't want to make the hole (once I pull out the screw) any larger to accomidate (did I spell it right?) the plug I put in. So, what do you think....should I say f*** it and go for it with a larger hole so the plug fits or have the garage put in a patch/plug from the inside?? I think I'm going for the garage........................
sambo42xa
Southern, NH

[tl1000s]

I always had a tire shop fix nail and screw holes. I've never had a problem with a plug leaking afterwards. I figure they do a lot of them, they know what they're doing, and the sealants they use are fresher than the stuff thats been sitting on the Walmart shelf for the past five years.

[sambo42xa]

All set! Had it repaired at a local Tire Warehouse for $19.00! They even removed the tire and put it back on for me. :thumbsup:

sambo42xa
Southern, NH