PDA

View Full Version : Fuses?

yariSB86
03-30-2013, 04:29 PM
I have no clue what I'm looking at in the in dash fuse panel.

My a/c control knob lights and center cluster dimmer switch no longer work.

What do I need to check/replace to fix this?

I have looked EVERYWHERE to find a diagram labeling what fuse and what plug does what with no avail.

Any and all help is greatly appreciated!

Thanks in advance guys.

-B


p.s. this failure is a result of installation of an aftermarket head unit. its a JVC single DIN headunit connected with a metra wiring harness.
CTScott
03-30-2013, 05:07 PM
Check the panel1 fuse in the panel that is under the bottom of the dash, by the hood release lever.
yariSB86
03-30-2013, 05:18 PM
http://img.photobucket.com/albums/v288/riseagainst86/photo10_zps17161326.jpg

That's what I see. which fuse is panel1? nothing I see is labeled that.
Betrivent
03-30-2013, 05:36 PM
check the plastic piece you removed to get to the fuse panel, there's a diagram on the back with labels.
CTScott
03-30-2013, 05:39 PM
http://img.photobucket.com/albums/v288/riseagainst86/photo10_zps17161326.jpg

That's what I see. which fuse is panel1? nothing I see is labeled that.

You are in the wrong place. Look under the bottom of there.
yariSB86
03-30-2013, 06:54 PM
Thanks CTScott! I checked the panel1 fuse. still good. Any other ideas?
yariSB86
03-30-2013, 06:55 PM
could I have missed something being plugged into the metra harness for the headunit?
CTScott
03-30-2013, 06:59 PM
Check the MET and GAUGE fuses as well. With the Metra harness the most likely issue would be popping a fuse if you connected something incorrectly or made the connections with the battery still connected and accidentally grounded something that should not have been.
yariSB86
03-30-2013, 10:04 PM
MET and GAUGE fuses were intact.
Rechecked PANEL1, it was bad.
Replaced PANEL1, it blew.
I must have a ground somewhere behind my headunit or amp...ill check my wiring tomorrow.

Thanks for the help again CTScott.
yariSB86
03-31-2013, 10:24 PM
So I checked all my wiring. Everything seems in order. I went ahead and respliced my head unit harness just incase. But without a spare 7.5 fuse I wont know for sure. Ill pick one up tomorrow morning when I leave work. Ill post when I install it.