PDA

View Full Version : 08 cup holder removal?


Melloreel
04-10-2013, 06:41 PM
I want to remove the cup holder "door" so I can clean all the previous owners coffemate out? I have the manual on disk, but it states only how to do it when removing dash? Does the door come off without removing glove boxes?

Also in the manual pic it is not clear if you pry out on the hinge or in?

Any thoughts?

bladesmith6
04-10-2013, 06:43 PM
Open the holder there is a screw down in the bottom remove that, then you will have to pry the sides out from the dashboard pulling forward. It does take a good amount of force but it will come out.

Melloreel
04-10-2013, 06:57 PM
Open the holder there is a screw down in the bottom remove that, then you will have to pry the sides out from the dashboard pulling forward. It does take a good amount of force but it will come out.

In the manual it looked as though that screw was to remove the air vent! And dash. Will give it a shot!
Do you pry out on arms?

bladesmith6
04-10-2013, 07:22 PM
yes i would try with fingers first or a plastic trim removal tool.

nookandcrannycar
04-22-2013, 04:16 AM
I want to remove the cup holder "door" so I can clean all the previous owners coffemate out?

Ugh. Gross (IMO..but not gross for you to relay...just gross on the previous owner's part). I don't remember if your purchase was dealer/craigslist/ebay/other. If mr miles sees this, he'll probably have that reaction several times over :biggrin: (and other members as well).

Melloreel
04-29-2013, 05:11 PM
Then. They wouldn't want to see what I found under the seat, when I took them out:eyebulge::barf:

Melloreel
04-29-2013, 05:15 PM
Ok! On a serious note. I have replaced the water pump, installed cruise control. But I cant get the @&$&@& cup holder out. Anymore force, and I will rip the dash out! It can't be this hard? How about it scott! Any thoughts?
I believe I would rather take the motor apart than try and get this @!$$& cup holder out!

CTScott
04-29-2013, 06:22 PM
Ok! On a serious note. I have replaced the water pump, installed cruise control. But I cant get the @&$&@& cup holder out. Anymore force, and I will rip the dash out! It can't be this hard? How about it scott! Any thoughts?
I believe I would rather take the motor apart than try and get this @!$$& cup holder out!

There is a piece of spring steel on the back side that gives it its detent. I find that it is easier to remove them if you first remove the screw and that spring. The problem is that you can only get to the screw if you lift the dash top, which means basically removing the whole thing.

Melloreel
04-29-2013, 06:57 PM
Thanks scott! That's what I wanted, didn't want to hear. So Q tips will have to do for now!

Kar98
04-29-2013, 08:25 PM
Thanks scott! That's what I wanted, didn't want to hear. So Q tips will have to do for now!

Maybe a few bottles of canned air?

cali yaris
04-30-2013, 01:46 PM
Windex, a used toothbrush and a vacuum. Please don't use your current toothbrush.

Melloreel
04-30-2013, 06:02 PM
Windex, a used toothbrush and a vacuum. Please don't use your current toothbrush.

I don't brush my teeth so will have to borrow one:eyebulge: anyone open to lending me theirs :thumbsup:

Thanks for tips though.

nookandcrannycar
05-02-2013, 01:06 AM
Then. They wouldn't want to see what I found under the seat, when I took them out:eyebulge::barf:

:bellyroll: