View Full Version : Putting on dust cover boot ring on ball joint
yaris4062007
04-21-2013, 03:14 AM
Is there special tool to install dust boot cover ring on ball joint?
yaris4062007
04-21-2013, 03:15 AM
:(
yaris4062007
04-21-2013, 03:23 AM
This happened after using ball joint fork :eek:
yaris4062007
04-21-2013, 03:25 AM
.
CTScott
04-21-2013, 07:43 AM
Did you rip the new boot by trying to use the for to get that ring on?
I would probably try two pairs of locking pliers to hold the ends while pulling them apart to get the clip into place. There is a special tool for spreading that type of clip, but it may not be something that you could get from a local autoparts store.
B2FiNiTY
04-21-2013, 11:37 AM
What Scott said. There are some special pliers. I've gotten them from sears before. Craftsman.
YarisSedan
04-21-2013, 12:27 PM
I hate using pickle forks on the ball joint it always garentees you will damage the boot. This is the actual tool and brand I keep in my tool box for this job
http://www.youtube.com/watch?v=7vweCmGwBiU
Its about 20 bucks at harbor freight or around 50 for the entire master kit.
yaris4062007
04-21-2013, 12:40 PM
No, that's old stock boot and new one still good. I tried to spread using two locking pliers but it doesn't spread enough to fit. Looks like i need special tool
yaris4062007
04-21-2013, 12:41 PM
You got any picture what it looks like .What Scott said. There are some special pliers. I've gotten them from sears before. Craftsman.
yaris4062007
04-21-2013, 12:42 PM
Yep I used that to remove it after fork failed I hate using pickle forks on the ball joint it always garentees you will damage the boot. This is the actual tool and brand I keep in my tool box for this job
http://www.youtube.com/watch?v=7vweCmGwBiU
Its about 20 bucks at harbor freight or around 50 for the entire master kit.
yaris4062007
04-21-2013, 12:51 PM
Can I use this to lubricate ball joint?? Thank you
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.