PDA

View Full Version : Factory rear fog lamp ?


JudgeM
09-06-2013, 05:03 AM
I have a 2005 Vitz RS (JDM). What I thought was just my rear reflectors also seem to be the fog light. In my Japanese manual there is a diagram showing the replacement of the bulb there. Also i have seen another RS with those lights lit up. I spent a few mins looking around in my car and could not see any easy way of checking if there is a bulb or any wiring there.

Anyone have any advice on how I can check it ?

i've put a pic of my reflector/light

http://www.yarisworld.com/forums/images/funkygarage/1952/2.jpg

Its the ones on the bumper.

CTScott
09-06-2013, 07:32 AM
Peek up under the bumper and see if there is a wire going to one or both of them. I think that the reflectors are only replaced with lights in certain markets.

yarisugi
09-06-2013, 11:59 AM
The ones that you have are the rear reflector-type.
You can buy the rear fog lamps but mostly likely you'll have to wire them up yourself. The rear fogs look like these.

JudgeM
12-31-2013, 12:32 AM
Where can I buy these from ?

Jerkratt
02-04-2016, 08:23 PM
Were can you buy the car side harness? Or does anyone know how they function? Are they essentially extra running/brake light? Or is there a switch for them like Audi?

CTScott
02-04-2016, 09:04 PM
Were can you buy the car side harness? Or does anyone know how they function? Are they essentially extra running/brake light? Or is there a switch for them like Audi?

On the Yaris / Vitz from areas where they are factory installed, they are controlled by the rear fog light switch and relay, which are separate from the front fog light switch and relay. I appears also that the rears can only be turned on when the headlight is on and the front's are on.

Jerkratt
02-04-2016, 09:09 PM
So I have the rear fog lights and I have the rear fog light harness what I essentially want to do is make them work like factory the problem is my car side plug only has two wires the fog light harness has all 10 if I remember correctly wires pinned to the connector. How can I obtain this switch and relay? Everything is installed (fog and harness wise only thing that works is 1 of the 2 license plate lights as I have the JDM bumper)

Jerkratt
02-04-2016, 09:13 PM
I should also add I have factory fogs and already removed my DRL Relay (ground out fog wire). Does the switch give option to one or the other? Or both at same time?