very notchey temp dial

[soldout]

I had to take apart my dials to trim some of the plastic away bc I bought smd led for my interior. Well I got my dials back together but the temp gauge has a notch half way through cold, right in The middle of cold/hot and half way through hot. What did I do wrong?

[CTScott]

I had to take apart my dials to trim some of the plastic away bc I bought smd led for my interior. Well I got my dials back together but the temp gauge has a notch half way through cold, right in The middle of cold/hot and half way through hot. What did I do wrong?

Are the notches there when the cable is disconnected from the control?

[soldout]

Yes.

[CTScott]

Yes.

OK. the gear train is off. If you turn it at all while it is apart that occurs. You will have to pull it back apart again and experiment with it. I haven't messed on up in a while, but I don't recall there being alignment marks, so it's a bit of a hassle to get it back right. After the first time that I did that I learned to mark the gears when I took one apart.

[soldout]

Thanks scott, im pretty mechanically inclined myself but I could not for the life of me figure out why the dial was notchey. I took it apart and put it back together a few times and now the notch is gone, weird! The dial had full range and motion just notchey. Everything is good now though thanks.