[HELP] Dropped knife into centre console

[mussie]

Was pulling apart the centre console and dropped my knife into the part which falls into the middle panel which has the gears and handbrake. What do i need to undo the bolt on it ? just a torque wrench ? what happens if it fell further down is it a possible hazard?
thanks

[MyzticZ3r0]

In the center console, behind the e-brake, there should be a cup holder. If I remember correctly, you only need a screw driver. Once you remove the screw, you can lift the center plastic up. I don't see it causing any problems if kept there, but someone may find treasure if you ever sell the car =].

Edit: I changed the bolt into a screw for easier access. I just used a interchangeable wrench to take off the bolt.

[mussie]

Undid the bolt and now have a problem lifting the plastic piece over the hand brake :P keeps getting hooked. any tips?

[dj92]

Gently lift its front end upwards.
Be careful not to break the clips - I'll cross my fingers ;)

[MyzticZ3r0]

You have to unclip the smaller plastic piece near the ebrake - pop it out. Afterwards, you can raise the center plastic by the back and move the ebrake in position.

[mussie]

DONE :D TY