robertkk
06-08-2014, 05:02 AM
Hello
I am trying to install RVC in my mother's Yaris.
It's European hatchback, built in 2012 in France.
To make everything smooth, I got used Toyota Touch unit, Toyota camera and hatch wiring harness.
I was quite happy to see extra plug waiting in the radio compartment looking like F117 connector, so just replaced the hatch harness with camera connector.
Unfortunately nothing happens when putting reverse.
I'm not to familiar with Toyota system, so not sure if information like, "no signal detected" should appear in the screen or something.
I cannot exclude that unit or camera is broken at this stage, however radio, including steering wheel controls is working correctly.
I checked all other threads and found wiring for RVC, however it looks like my F117 connector cables are different?
According to the diagram, I'm missing pins 9 and 10 and have only 5 wires - is it ok ?
So I'm wondering if I'm missing CAN signal from reverse - or missing wires from hatch to radio.
I'm going to check the voltage on the pins and wires continuity with the meter, but the problem is that I have very limited access to the car, so any suggestion would be highly welcome.
Any thoughts?
I am trying to install RVC in my mother's Yaris.
It's European hatchback, built in 2012 in France.
To make everything smooth, I got used Toyota Touch unit, Toyota camera and hatch wiring harness.
I was quite happy to see extra plug waiting in the radio compartment looking like F117 connector, so just replaced the hatch harness with camera connector.
Unfortunately nothing happens when putting reverse.
I'm not to familiar with Toyota system, so not sure if information like, "no signal detected" should appear in the screen or something.
I cannot exclude that unit or camera is broken at this stage, however radio, including steering wheel controls is working correctly.
I checked all other threads and found wiring for RVC, however it looks like my F117 connector cables are different?
According to the diagram, I'm missing pins 9 and 10 and have only 5 wires - is it ok ?
So I'm wondering if I'm missing CAN signal from reverse - or missing wires from hatch to radio.
I'm going to check the voltage on the pins and wires continuity with the meter, but the problem is that I have very limited access to the car, so any suggestion would be highly welcome.
Any thoughts?