WTB Stock radio wire harness

[wsladaritz]

Specifically I am looking for the D74 plug (20 pins) with at least a few inches of wire. I have the stock radio and I'm trying to get an aux input working. I do not have the stock aux input so if anyone has that I would be willing to buy that as well.

The Reason: Powering stock HU and front speakers with a PC PSU in a home made boom box project for my garage.

[CTScott]

LOL - There is nothing better than an OEM radio for a garage radio.

I don't have a connector D74 on hand, but I do have the pins for the connector, which can just be heat shrunk to keep them touching the pins next to them.

[wsladaritz]

That's a wonderful idea CTScott! I just quit when I saw how close together they were and realized I wasn't going to be able to solder em on.

If I got my research right the pins should be:

Audio Left input: 17
Audio Right input: 15
Ground 16 for audio and 19 to tell it an external device is connected.

Am I missing anything?

[CTScott]

That's a wonderful idea CTScott! I just quit when I saw how close together they were and realized I wasn't going to be able to solder em on.

If I got my research right the pins should be:

Audio Left input: 17
Audio Right input: 15
Ground 16 for audio and 19 to tell it an external device is connected.

Am I missing anything?


Correct - Except 16 is the shield (ground around the audio wires) and 19 doesn't get grounded, but instead gets a 2.2K ohm resistor to ground to enable aux mode.

[wsladaritz]

Excellent! Thanks for the assistance!