View Full Version : 2015 yaris, rear view camera
Eduardo_mty
10-12-2014, 01:53 PM
I Will tray to install this Chinase Rear view camera (picture 1)
I try to remove this plastic, but i can't.(picture 2)
I found this connector, i think this is for rear view camera
Eduardo_mty
10-12-2014, 02:35 PM
I found This
Eduardo_mty
10-12-2014, 02:49 PM
And this http://tapatalk.imageshack.com/v2/14/10/12/8e5c95ecdb86c604874b179f59d6d777.jpg
Eduardo_mty
10-12-2014, 11:01 PM
Ctscott do you know the part number for this 24 pin connector
CTScott
10-12-2014, 11:31 PM
Ctscott do you know the part number for this 24 pin connector
No. The camera is not documented in the US wiring diagrams, so that connector is not even shown.
CTScott
10-12-2014, 11:41 PM
OK - Found the connector in Europe. It is part of a the installation kit for the camera: PZ457-B0140-00 (which includes the harness and pins and the connector.
The OEM camera is: PZ473-B0140-00
Eduardo_mty
10-12-2014, 11:56 PM
Thank you ctscott, in Do you have the link?...
Eduardo_mty
10-13-2014, 12:01 AM
I found pz457-b0140-00, around 60 usd, this is the connector?
http://partsale.eu/spare-parts/view/TOYOTA-PZ457B014000-74818965
Eduardo_mty
10-13-2014, 12:02 AM
But no the oem camera
CTScott
10-13-2014, 09:05 AM
Doing a search for the camera part number shows a couple of European sites with it. Try emailing the folks at the link below, as I have always had good luck ordering European Yaris parts from them:
http://genuineserviceparts.com/
Eduardo_mty
10-13-2014, 01:02 PM
CTScott, do you think, this will work
http://www.ebay.com/itm/Toyota-Display-Audio-Entune-Backup-Reverse-Camera-Rear-Kit-RAV4-Corolla-Prius-/111317957504?hash=item19eb113b80&vxp=mtr
or this
http://www.ebay.com/itm/OEM-BACK-UP-reverse-CAMERA-ADAPTER-harness-for-TOYOTA-SUBARU-SCION-Plug-and-play-/121456866854?pt=Motors_Car_Truck_Parts_Accessories&fits=Model%3ARAV4&hash=item1c4764b626&vxp=mtr
CTScott
10-13-2014, 01:57 PM
The second would not be of use unless you were using an aftermarket radio. The first may work, but I am not sure, as the bare camera (86790-0d010) is a unique part number to the Yaris, where many of the other vehicles with cameras share a common part number.
Eduardo_mty
10-13-2014, 03:01 PM
i will buy
http://www.ebay.com/itm/OEM-BACK-UP-...64b626&vxp=mtr
thank you for your help
i will pay the same price for harness, and the shipping .
ucsmfu
10-19-2014, 07:28 PM
i will buy
http://www.ebay.com/itm/OEM-BACK-UP-...64b626&vxp=mtr
thank you for your help
i will pay the same price for harness, and the shipping .
which reverse camera did you end up buying and using ?
can't you just splice the wire to reverse light signal ?
Thanks
Eduardo_mty
10-19-2014, 08:33 PM
The camera I bought in alibaba.com, 8 months ago
Now i waiting a cable video that bought with autoharnesshouse.com
Eduardo_mty
11-09-2014, 11:40 PM
I got the cable from autoharnesshouse.com and Now i will try to connect.
I connected to the head unit.
I run the cable camera, And + wire, And - wire. To the front of the car.
Brian from autoharnesshouse.com, tell me that i need to use the red wire to power the camera And negative wire i was connected to a screws under the dash
Now i need to connect to reverse wire.
I asked in other post..
And CTScott help me. But i can't found how to connect.
Eduardo_mty
11-10-2014, 01:27 PM
one question.
i will take the + wire, from reverse light, i will run from back to front.
one pin on the harness, is the reverse light trigger, then,
i will connect .. + wire from reverse light, + red wire from harness and +wire from pin trigger?
this is correct?
Eduardo_mty
11-10-2014, 01:49 PM
pictures
CTScott
11-10-2014, 02:21 PM
one question.
i will take the + wire, from reverse light, i will run from back to front.
one pin on the harness, is the reverse light trigger, then,
i will connect .. + wire from reverse light, + red wire from harness and +wire from pin trigger?
this is correct?
I would think that the + wire should get ignition switched +12 V power and the reverse wire would connect to the red back-up light wire. Does the documentation explain the pin trigger? I would think that it would be a separate way of turning the camera on (like when you are not going in reverse).
Eduardo_mty
11-10-2014, 02:26 PM
reverse trigger instruccions
http://www.autoharnesshouse.com/19867_add.html
CTScott
11-10-2014, 02:31 PM
reverse trigger instruccions
http://www.autoharnesshouse.com/19867_add.html
Ah, the reverse trigger is just the opposite of what I was thinking - It is an input to the head unit to tell it that the car is in reverse.
Eduardo_mty
11-10-2014, 02:34 PM
the trigger pin, is the #2 from left to right..opposite the "security clip"
Eduardo_mty
11-10-2014, 02:49 PM
harness position
Eduardo_mty
11-10-2014, 09:28 PM
I was thinking, i "resolve" my doubt.
the + wire from camera, i will connect to + wire from harness.
the pin trigger from harness to + wire from reverse light.
this is correct?
CTScott
11-10-2014, 11:21 PM
I was thinking, i "resolve" my doubt.
the + wire from camera, i will connect to + wire from harness.
the pin trigger from harness to + wire from reverse light.
this is correct?
Yes.
Eduardo_mty
11-17-2014, 09:01 PM
doubt about reverse trigger pin..
This is the reverse trigger that i marked with red line ??
see pict..
Eduardo_mty
11-23-2014, 08:48 PM
Today i was installed my rear view camera...
i was an error, with the connectors.. but the seller help me, and show me my error
pic 1 . the harness,
pict 2. my error
pict 3. left foot reverse wire
pict 4. correct pin connector for reverse trigger
pict 5. head unit show the camera image
bronsin
11-24-2014, 08:36 AM
I was walking around the block the other day and was almost runover by a Corolla backing out of its driveway. It was about 10 feet from the sidewalk and I didn't see the driver in the car or hear the engine running. As I walked behind it it suddenly started moving towards me. I screamed "Look Out!!!" and the driver stopped just as the rear bumper touched me.
Yeah it had a backup camera in it which the driver didn't look at. Not only that, even if she DID look I was completely out of the camera view walking from the drivers right to left.
So the camera only works if the subject is right behind the vehicle, not moving.
Just a heads up all you people.
hondajt
11-24-2014, 09:05 AM
^^I highly doubt anyone here is using the backup camera solely for safety. I only use one for parking in tights spots.
Eduardo_mty
11-24-2014, 09:15 AM
Plus the rear view camera, i will install rear back sensor, in 2 weeks
bronsin
11-24-2014, 09:57 AM
^^I highly doubt anyone here is using the backup camera solely for safety. I only use one for parking in tights spots.
It shouldn't be used for safety at all! The driver needs to look themselves 180 degrees behind the vehicle when backing up.
Now that I think of it, if the camera is used in tight parking spaces for backing up and the driver doesn't do a 180 before starting to reverse they could run someone over who is moving towards the vehicle but is out of the cameras field of view.
Because of advertising on TV I imagine A LOT of people think of a rear view camera as a safety device.
Which it isn't!
ucsmfu
12-15-2014, 05:13 AM
so your reverse camera works good ?
here's mine :)
http://oi58.tinypic.com/292wept.jpg
screenprinter
05-27-2015, 05:43 PM
Know this is older, but here's a couple of YouTube videos that show how to hook up a Reverse Camera. Nothing fancy:
Wireles:
https://www.youtube.com/watch?v=BqbxyvP3u8A
https://www.youtube.com/watch?v=SDrAacDFvFI
Adding the Camera Part 1: https://www.youtube.com/watch?v=LBzoD97BcHQ
Adding the Camera Part 2: https://www.youtube.com/watch?v=Y4owoUL8UDo
yarisbug
10-17-2017, 03:06 AM
Hate to revive an old thread, but i'm doing the same thing here with the exact same wiring harness and am a bit confused as to where/what i tap into to provide power to the camera; would I tap into the reverse light and wire that to the camera's power cable, or actually run a power wire from the camera itself all the way to the front and splice that into the red wire on the harness?
Any help would be greatly appreciated.
Kaotic Lazagna
10-17-2017, 07:38 AM
Hate to revive an old thread, but i'm doing the same thing here with the exact same wiring harness and am a bit confused as to where/what i tap into to provide power to the camera; would I tap into the reverse light and wire that to the camera's power cable, or actually run a power wire from the camera itself all the way to the front and splice that into the red wire on the harness?
Any help would be greatly appreciated.
For the cam, I tapped into the reverse light wire in the taillight. The trigger for the head unit, I tapped into the red wire in the fuse box.
phpist
09-15-2021, 01:17 PM
I Will tray to install this Chinase Rear view camera (picture 1)
I try to remove this plastic, but i can't.(picture 2)
I found this connector, i think this is for rear view camera
what this really rear camera connector?
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.