Too cold to install spoiler?

[CT_CJ]

Hey,
I live in the northeast and my spoiler *finally* came (ordered in October). It was really nice a week ago, but it seems 30s maybe low 40s are here to stay.

So my question is would this cause issues with installing? Contraction /adhesion etc.?

The spoiler came with 3m tape and two bolts/nuts.

Cheers.

[Bluevitz-rs]

nothing a heat gun or hair dryer can't fix for heating up the spots for the adhesive.

[CT_CJ]

Thanks Blue! Did it yesterday, heated the tape and the areas it needed to go enough where it seems likes it adhered well. Two bolts went in easy. As a note to anyone else doing it, you don't need a hole saw to do the right most one. I just used a 1/2 drill but and magnetic tool to place the nut on the bolt. A small rubber washer and 1/2 plastic plug from Lowes sealed it up nice.

[Bluevitz-rs]

Post up a pict of the final product.

[CT_CJ]

http://imgur.com/a/CmR3J

[ern-diz]

:thumbsup:

[CT_CJ]

Thanks. Now to do something about those terrible hubcaps..lol

[Bluevitz-rs]

Nice! Looks like a factory install.

[tmontague]

Nice install, looks clean