View Full Version : Wires for reverse light bulb
GibbsYaris07
09-08-2017, 07:20 PM
I'm trying to install this reverse camera and I have the wires ready however I don't know which wires are for the reverse bulbs to splice in. I have a picture of the wire set for rear bulbs. Can someone tell me the + and - wires for the reverse.
GibbsYaris07
09-09-2017, 09:07 PM
anyone can help?
Whiplash
09-09-2017, 10:10 PM
Can you tell by looking in the trunk?
Kaotic Lazagna
09-10-2017, 04:44 AM
What I did was looked at the reverse bulbs, looked at its wire connector, and guess (correctly) on which wire was positive and which was negative (had a black stripe on it iirc, whereas the positive was a solid color that I can't remember).
Also, gotta make sure you connect your HU's trip wire as well (I'll be doing that tomorrow as right now I have to manually turn on the camera once I'm in reverse)
http://www.yarisworld.com/forums/showpost.php?p=657923&postcount=10
GibbsYaris07
09-10-2017, 10:25 AM
I think I going to skip installing the reverse camera. I really don't need on for this tiny car anyway. lol
Whiplash
09-10-2017, 01:05 PM
You can also look for wires around the shifter if that's easier.
2007YarisBase
10-30-2018, 07:10 PM
Of the five wires on the rear light harness, did you figure out which is the correct wire?
TIA
GibbsYaris07
02-01-2019, 11:02 PM
nope, I tried all the wiring and it still didn't work. For this little ass car, its more trouble than its worth so I said f*** it and abandoned this install.
myfirstyota
02-02-2019, 10:59 AM
In my 2008 3 door, it's the brown (I think, my eyes kinda suck with colours)
http://i.imgur.com/pkGMGXc.jpg
http://i.imgur.com/y5FX3bq.jpg
Where the yellow wire enters the connector is the spot for reverse positive.
You can see the shrink wrap where I already made the mistake hahah.
I turned the reverse light into a diy rear fog light. That's why I have the yellow wire re-pinned into the connector where the reverse positive goes.
GibbsYaris07
02-07-2019, 09:39 AM
tried that one and it didn't work.
myfirstyota
02-07-2019, 12:31 PM
Can't help you them bro. That's the one on my car.
vinooooo93
05-15-2019, 10:41 AM
Red is positive, black is negative (ground)
Test with circuit tester - positive cable should light up when in reverse, negative cable should not light up when car on/off or changing gears
vinooooo93
05-15-2019, 11:16 AM
Might be different colour to mine but here is the diagram that shows position of positive and negative cables (Terminal 5 and 6 for Sedan respectively).
Always best to confirm positive wire with current tester when gear is put in reverse - should light up. Hope this helps
nashyaris
06-15-2019, 12:51 AM
Might be different colour to mine but here is the diagram that shows position of positive and negative cables (Terminal 5 and 6 for Sedan respectively).
Always best to confirm positive wire with current tester when gear is put in reverse - should light up. Hope this helps
I used a test light and hooked it up to wire 5 positive (brown) and wire 6 negative on the rear drivers side light on a 2008 Yaris sedan - this was the correct reverse wire! Hooked up the backup camera like pro. Thanks for help y'all! :smile:
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.