PDA

View Full Version : VITZ NCP91 RS MAF HELP

JRHPNG
09-20-2017, 02:04 AM
Hi,

I am building up my own intake and have found this pipe online made by Simota.

As my car is still in transit, I am gathering bits and pieces now, otherwise I would simply measure it myself.

Can anyone assist me with the measurements that they show so I know the MAF will fit into this?

Thanks in advance!
WeeYari
09-20-2017, 09:11 AM
Measure your own MAF. Would take you about as long to do as it took you to make this thread.

Sent from my Elite_5_5_Octa using Tapatalk
JRHPNG
09-20-2017, 05:20 PM
Measure your own MAF. Would take you about as long to do as it took you to make this thread.

Sent from my Elite_5_5_Octa using Tapatalk

Original post edited.
JRHPNG
09-20-2017, 08:29 PM
Measure your own MAF. Would take you about as long to do as it took you to make this thread.

Sent from my Elite_5_5_Octa using Tapatalk

** Comment removed
SirDigby
09-20-2017, 11:38 PM
ha!
Bluevitz-rs
09-21-2017, 12:28 AM
Dick

Here in Canada it's pronounced "Richard"
WeeYari
09-21-2017, 10:05 AM
King Richard (Dick)I shouldn't even bother but since I am not a Dick, the critical measurements of 55 and 30 are correct. At least for a North American market Gen2 they are. No reason to believe yours would be any different.

Peace Out!

(for anyone late to the thread reading this, the original post had been subsequently edited to indicate that the vehicle is in transit)

Sent from my Elite_5_5_Octa using Tapatalk
JRHPNG
09-21-2017, 08:57 PM
I shouldn't even bother but since I am not a Dick, the critical measurements of 55 and 30 are correct. At least for a North American market Gen2 they are. No reason to believe yours would be any different.

Peace Out!

(for anyone late to the thread reading this, the original post had been subsequently edited to indicate that the vehicle is in transit)

Sent from my Elite_5_5_Octa using Tapatalk

Was my fault for not clarifying in the original post - I greatly appreciate your response. Thanks,