driveline noise after clutc/flywheel install

[Brettguy]

so my latest symptom has been a loud humming under load at 3-4k rpm, its very obvious/annoying on the highway, related symptoms is vibration of the clutch pedal at all times. what does anyone think this could be? a transmission specialist down the road sounded confident that the motor mounts were placed back incorrectly, and ive also read online about the possibility of input/ output shaft misaligment. my initial issue of a chirping clutch fork was solved with lithium grease but i feel like the throwout bearing is vibrating more than it should to begin with (after the replacement), any ideas? f*** this is so heartbreaking i love my car :cry:, if anyone experienced could chime in it'd be much appreciated!

[tmontague]

It's going to be really hard to say without either as much info as possible and/or disassembling the trans from the engine.

If the clutch pressure plate wasn't perfectly centered on install it could cause the symptoms you're experiencing.

The engine/trans mounts would be the cheapest and easiest to check so start with that