Penguin garage axle spacer

[Tskm2]

Search for a set or someone with draw of all measure to made one. Fors 06-07yaris

[tmontague]

If you can wait until the spring I will he selling my 10mm penguin spacers with camber washers.

I'm going to a wider 225 track tire and that wont fit with the 10mm spacers

[Leegamer]

Are you just looking for slip-on spacers? If so there are a billion companies that sell them.

[Tskm2]

Pm's tmontague

I run wheel spacer on all my car/truck. But couple years ago a made a set of axle spacer for my jetta mk2 and it so much better and on wheel bearing too

[enviri]

found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

https://i.imgur.com/XdCbAci.jpg

[myfirstyota]

If any Canadians are looking for a more local sale of their spacers, I'd be interested

[06YarisRS]

found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

https://i.imgur.com/XdCbAci.jpg

Interesting. Mine weren't a bad install at all. Getting the hub off before the spacer install was tough, but putting it all back together was a breeze, but I did have the mechanical advantage of the bolts. However, removal, that may be a different story.

Now you've got me wondering...does my '06 have ABS? Haha. The install was a while ago.

[enviri]

go slam your brakes and report back lol

[06YarisRS]

go slam your brakes and report back lol

:laugh: - a valid test for sure. However, since it's still up on stands with the front torn off, I'll look for the sensors. LOL.

[myfirstyota]

found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

https://i.imgur.com/XdCbAci.jpg

I've had to use a slide hammer every time to get the rear hubs out.

[tmontague]

I opted for the air chisel when I had to remove them to install the spacers. Now I never have any issues since everything is covered in anti seize. If only the factory would do the same...

[Tskm2]

In search again!

[Tskm2]

Or someone he's able tho draw/template exactly on sheet and mail for a made custom one. I dont have old/scrap bearing to take measure

[enviri]

https://imgur.com/a/eotSAt7 on regular 8 1/2 x 11 :P

[Tskm2]

Alrigth thank! I print it and try the template!

[06YarisRS]

I think this will make many people happy!