Hub Removal for Wheel Bearing or ABS Sensor - The Easy Way

[IndestructibleYaris]

Take a bolt and nut. Push the bolt through a hole in the hub and thread a nut on the other side. Jack the hub off the backing plate and axle/knuckle.

https://youtu.be/kxB9xCZ-w5Q?si=383D_-3WqNW-aeUW

[Billiam]

This is the process I used to remove the bearings when I had to replace my rear beam. It works.

[IndestructibleYaris]

This is also for doing rear ABS/wheel speed/skid sensors which are lightly pressed on the back of the hub bearing, and they require the hub to be completely removed first.