Log in

View Full Version : DIY - NST CR lite pulley

kurokoma-kun
10-20-2008, 02:10 PM
Due to the hack attack I'm re-posting a few DIYs I had in my files in PDF form... it's the whole thread, up to the point where I saved it. Many thanks to the original poster.
rningonfumes
03-22-2009, 12:53 AM
Chino, anyway we could get the pics in your install? The pdf doesn't show the pics.
Yariz
04-06-2010, 01:00 PM
Please, I have not been able to find this DIY since it was moved, everything I have found points to the "MOVED" page. That doesn't do me a lot of good.
Yariz
04-06-2010, 01:59 PM
anyone know where I can d/l the PDF with pictures? W/O a ridiculous spam filled download site?
rningonfumes
04-06-2010, 02:04 PM
http://www.microimageonline.com/forums/forum.php

I said if that just forums doesn't work, try just microimageonline didn't work, take off the forums part. You will find your DIYs in there.

..In other words, look around for the forum section. Microimage is not a spam site.
Yariz
04-06-2010, 02:18 PM
http://www.microimageonline.com/forums/forum.php

I said if that just forums doesn't work, try just microimageonline didn't work, take off the forums part. You will find your DIYs in there.

..In other words, look around for the forum section. Microimage is not a spam site.



Didn't say it was, I have talked to Garm many times. I am aware of what it is... He has been working on it, and its not done. Don't worry about it. I am done with trying to do this for now. I have other stuff to do, and I will need different tools so I am good.