 |
 |
|
|
08-10-2010, 04:38 PM
|
#1 |
 Drives: 2008 Yaris Hatchback Join Date: Jul 2010
Location: Mass
Posts: 15
|
So, I'm going to drill some holes in my roof...
I just ordered some parts so I can install a Yakima roof rack on my 2008 Yaris hatchback. I'm planning to install Yakima Control Towers via the Landing Pad 7 bases. This will require me to drill 2 holes in the roof per tower. Then I'll install the blind fasteners that come with the bases so I can bolt them into the roof. My question is: How do I ensure that I don't drill into something important? I know there are antennae wires and wires for the dome lights running above the headliner. After looking at the repair manual for the car it looks like I'll be able to avoid those wire but I'd like to be sure about this. Has anybody pulled the headliner before?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roof Racks and FE | noraebong | Fuel Economy Forum | 7 | 03-23-2010 02:40 PM |
| Highland Roof Racks(?) | YAR1S | Cosmetic Modifications (Exterior/Interior) | 3 | 12-07-2009 03:40 PM |
| Punching Air Box Holes | schreck | Performance Modifications | 11 | 05-07-2009 04:59 PM |
| No Drill roof rack available for Yaris 3 door? | kythunder | Cosmetic Modifications (Exterior/Interior) | 7 | 04-11-2009 04:35 PM |
| DIY: Yaris Hatch grill block/air dam | yarswiss | DIY / Maintenance / Service | 0 | 10-26-2008 06:52 PM |
Threaded Mode