My yaris lift back SQ install - Toyota Yaris Forums

cm_ls1 · 12-07-2010, 08:22 PM

ok made a bit of progress , started sound deadening the doors, inside and out, covered all service holes (used that plastic sheeting that real estate agents use for their signs- waterproof and light), another nice surprise was the yaris had cables insted of push rods for the mechanism - easy to seal, although i did go over the wiring - hoping never to hve to access it

I thought long and hard at housing the midbass in custom made kickpanels , but the work needed is a bit beyond what i want to take on at the moment, you see being rhd the accel pedal is hard right against the kickpanel and leaves barely any room.

The door opening is at the lower front, near where the kickpanel is anyway just need to get the axis/angle right with an angled spacer , there is quite a bit of room between the door card and the door metal, although these oz's are a good 3" deep!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 07:50 AM
Zage Turbo Kit Install - Toyota Yaris	Focus_Sh1ft	Forced Induction Forum	160	02-06-2022 08:14 PM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 04:54 PM
Install a Yaris deck into a Matrix... bad idea?? Help needed!!	SimmZ	In Car Entertainment + Electronics (audio / video / alarm)	4	12-17-2006 01:01 AM

12-07-2010, 08:22 PM	#11
cm_ls1 Drives: Yaris 07 HB Join Date: Jul 2010 Location: Oz Posts: 28	ok made a bit of progress , started sound deadening the doors, inside and out, covered all service holes (used that plastic sheeting that real estate agents use for their signs- waterproof and light), another nice surprise was the yaris had cables insted of push rods for the mechanism - easy to seal, although i did go over the wiring - hoping never to hve to access it I thought long and hard at housing the midbass in custom made kickpanels , but the work needed is a bit beyond what i want to take on at the moment, you see being rhd the accel pedal is hard right against the kickpanel and leaves barely any room. The door opening is at the lower front, near where the kickpanel is anyway just need to get the axis/angle right with an angled spacer , there is quite a bit of room between the door card and the door metal, although these oz's are a good 3" deep!