Quote:
Originally Posted by kngrsll
i think the opposite may be better. The top fixed perch seems a bit smaller than 5.5" just off the top of my head, so i think the pig tailed end would fit better there, while the bottom perch is just wide and flat.
As an alternative, I think it would be nice to come up with a way to secure the spring down flat perhaps if that set up must be done. Maybe drill a couple holes and run a clamp or something to keep it down, i dunno.
Care to expand on your idea Joel?
|
the silk roads utilize the weephole to bolt down the perch. can't remember if it was top or bottom, get RussellTehPirate to expound..
and i'm not the same chassis so we're talking mcintosh/fuji apples here...
as far as making conical mounts, what about grabbing some energy suspension urethane parts? i'm sure we can figure out SOMETHING that's already a stock part + a bolt/washer/nut...