Remote Start DIY Wiring Guide 2006-2010 Yaris

[WestCoast]

Good to know, and where is the Emergency Brake pin in my 2007 auto transmission yaris?

[CTScott]

Originally Posted by WestCoast

Good to know, and where is the Emergency Brake pin in my 2007 auto transmission yaris?

The yellow wire at the base of the ebrake lever or the yellow wire in pin 4C-2. The ebrake is typically not required for remote starters, except for with manual trans.

[WestCoast]

Do my auto trans car still don't need the Door Trigger input for my remote start?

[CTScott]

Originally Posted by WestCoast

Do my auto trans car still don't need the Door Trigger input for my remote start?

Check the manual for your remote starter. Most do not require that, as they can be used with cars with manual locks.

[WestCoast]

Where to output my (+) 12V Siren if i my car don't have the arm system?

[CTScott]

Originally Posted by WestCoast

Where to output my (+) 12V Siren if i my car don't have the arm system?

Unless you are adding a siren you won't need to connect that.

[WestCoast]

My CM6200 said I need cut the green loop wire inside the brain module, but I can't find it, where is my green loop wire?

[CTScott]

Originally Posted by WestCoast

My CM6200 said I need cut the green loop wire inside the brain module, but I can't find it, where is my green loop wire?

It is inside of the remote starter, not a wire on the car.

[WestCoast]

Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).

[CTScott]

Originally Posted by WestCoast

Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).

I have only installed a remote starter on a Yaris which has the engine immobilizer and therefor required the key bypass module. It sounds like even though yours does not have the immobilizer that the ECM wants to see the "unlock warning switch". It is a 2 pin connector on the ignition switch with a yellow and a white/black wire. As a quick test, just jump the yellow to the white/black by shoving a piece of wire in the back of the connector. If it remote starts with that jumped, then you will need to hook the yellow wire to the start #2 output of the remote starter.

[WestCoast]

You are the amazing man CTScott, I never done this before, but every thing works great now.

[CTScott]

Originally Posted by WestCoast

You are the amazing man CTScott, I never done this before, but every thing works great now.

Nice! I am glad to hear it is done and working.

[eseibel67]

I am trying to install Avital 4003 so I can use the existing factory remote lock signal as a trigger on an 07 Yaris Sedan.

On connector GD1, there is a brown wire on pin #5, and there is also a brown wire on pin #7. Turns out that the brown wire on pin #7 is the negative (-)lock pulse.

[eseibel67]

I was wrong on post above. The negative pulse on connection above does not have enough juice to trip the remote starter signal.

Instead, I used the passenger unlock (+) pulse and inverted it with a relay to give the remote starter the (-) trigger signal it wants. This wire is located at connector 4H, the pink wire at pin #18.

[chadcox82]

New to the forum but joined specifically because of this thread. I am thinking about installing a remote start on my girlfriends 2007 yaris with power locks but no factory keyless entry. Any suggestions for a simple, reliable yet relatively inexpensive remote start/keyless entry? I was looking at the VIPER 4105V, Are there any other systems you would suggest?

[CTScott]

Originally Posted by chadcox82

New to the forum but joined specifically because of this thread. I am thinking about installing a remote start on my girlfriends 2007 yaris with power locks but no factory keyless entry. Any suggestions for a simple, reliable yet relatively inexpensive remote start/keyless entry? I was looking at the VIPER 4105V, Are there any other systems you would suggest?

That viper would be a good choice. I am still very happy with the UltraStart that I installed on my 09, back when I got it in October of 2008. I have not had a single issue with it in the 5 years that is has been on there and the range if awesome compared to Avital that I installed on my 08.

[JoeVR]

Hi Scott,

Thank you so much for this great page. I have a 2008 Yaris with power locks but no remote. I would really like to put a remote start and lock/unlock. I don't really need an alarm for it.

I was looking at the suggested models in your document from a few years ago, and I have found most of them are discontinued.

Can you suggest an updated model that would do remote start & lock/unlock that would work on my 2008 Yaris?

Thanks! I really appreciate any helpful suggestions you may provide.

[CTScott]

Originally Posted by JoeVR

Hi Scott,

Thank you so much for this great page. I have a 2008 Yaris with power locks but no remote. I would really like to put a remote start and lock/unlock. I don't really need an alarm for it.

I was looking at the suggested models in your document from a few years ago, and I have found most of them are discontinued.

Can you suggest an updated model that would do remote start & lock/unlock that would work on my 2008 Yaris?

Thanks! I really appreciate any helpful suggestions you may provide.

I just picked up an Ultra Start 1272 XR Pro off ebay for the 2007 I am currently rebuilding for a buddy of mine. $47 is a great deal for it:

http://www.ebay.com/itm/261152420077...84.m1423.l2649