Did the "Home Depot" lip.

[matthewai]

guys the streets of brooklyn are tough i avoided a drunk driver and hit a monster pot hole or dip in the road whatever it was has ripped my little stock lip thing off so i want to do the hd one. from looking at you guys it just screws into the holes that are there already and maybe some extra 3m tape, and it should be fine correct?

[matthewai]

Originally Posted by mazilla

You guys see this? I'm pretty sure it's the garage door seal re-packaged...LOL

It's ONLY 35.00!

http://www.ebay.com/itm/TOYOTA-EZ-LI...item27bc913389

wait how much is it regular from home depot?

[JumpmanYaris]

KL why is urs so wide?

[JumpmanYaris]

The seal ofcourse

[TickleTimeTim]

That 3m does not wanna hold to the rubber. Gonna drill small holes and do the zip tie route I guess. Can't figure out the best way to position it so that it would look like a legit lip.

[ROCKLAND TOYOTA]

Originally Posted by TickleTimeTim

That 3m does not wanna hold to the rubber. Gonna drill small holes and do the zip tie route I guess. Can't figure out the best way to position it so that it would look like a legit lip.

you need the 3M BLACK tape #06383........

[TickleTimeTim]

Originally Posted by ROCKLAND TOYOTA

you need the 3M BLACK tape #06383........

Thank you, ill hit home depot up tomorrow

[TickleTimeTim]

At home depot and they don't have the tape. Lame.

[matthewai]

its pretty good i guess haha hopefully it stays on hahah

[nobodywise]

Originally Posted by mr.white_hb

**Not Slow Speed Internet ready -> a few pics**

This is my "Home Depot" Lip DIY Version 2.0
(1 long garage door seal cut it half and sicked together upside down)


I used Double-side tape with plastic door trim cut flat and sicked it to the bottom of the lip edge to stiffen it.


Test Fitting to see how it looks


DIY Front Lip complete. ... I wonder though if vinyl lettering would stick to the rubber ... if it can maybe I will add a cool vinyl sticker to it.

I took the idea of this new style Lip from here:
http://forums.nasioc.com/forums/show....php?t=1526863 (Credit goes to NASIOC Fourm user Mobutusan, for Front Lip Version II)

See where my Falkin logo is, I'm thinking of blacking out the white area there with black matte vinyl ?!? make the front look more agressive, what you guys think?
Next Project... DIY "Home Depot" style side skirts... might try paint the rubber as well, maybe plasti Dip spray paint will work!?!

What size rims are those?