installed head unit... - Toyota Yaris Forums

punch · 06-23-2006, 04:02 PM

2007 yaris sedan
ok, enough about the wife, today i installed an Alpine head unit, using the 2006 echo install kit, and toyota wire kit..

the echo kit was an AI kit, and basically the only part used was the plastic plate and bin, the mounting brakets in the kit DO NOT work, i had to mount the head unit to the stock toyota brakets.

the plastic plate fits 'sorta" will be looking for another solution when a yaris specific kit comes out.

will post a dash shot later.

yarislover · 06-23-2006, 06:37 PM

I used the same kit what a pain. I used the original mounting bracket,grinded off the points that stick out on the side. You need to use the mounting bracket that comes with the kit to secure the trim. I cut 75% of the plastic and screwed it to the side along with the original bracket. It looks great and is secure but a little work to make it fit perfect. I will post pics when I have everything apart to run my amp cables.

Toddhata · 06-24-2006, 09:03 AM

After reading your comments on using a kit, I was thinking of buying either the Kenwood or Pioneer 1 DIN graphic equalizer. That way I could use the factory mounting bracket for both the Alpine head unit with the EQ below. Do you guys think that would be a lot easier than trying to get the kit to fit properly?

yarislover · 06-24-2006, 11:06 PM

That should work. You may have to watch for gap but all said and done it should fit. If it works out for you I would like to see some pics. I will take a pic tommorow and post it so you can see the finish. It does look good with the trim kit but if you have the EQ go with it, way nicer if it fits.

punch · 06-25-2006, 04:17 AM

thats not going to work, you still need a trim kit...

yarislover · 06-25-2006, 03:02 PM

your right you will need the trim kit unless you make a face plate

yarislover · 06-25-2006, 03:29 PM

here are some pics
http://community.webshots.com/photo/...93381954mNFpIU
http://community.webshots.com/photo/...93381954WcPjrB
http://community.webshots.com/photo/...93381954lmSHUB

There are more pics of my car at
http://community.webshots.com/myphot...ecurity=QXBHmH

Toddhata · 06-26-2006, 12:52 PM

ok, thanks for the info. I have a kit, just waiting for my eq and head unit to come in. I'll post pics when it's all finished.

eight_heads · 06-26-2006, 10:09 PM

does anyone know if changing the stock radio voids any electronic warranty?

mikeukrainetz · 06-26-2006, 11:34 PM

I installed my new deck before my first oil change, took it in and they didnt say a thing... dont know if they just didnt notice or what (cant miss the LED). I assume if you dont cut into any wires you dont have a problem.

yarislover · 06-27-2006, 06:51 AM

I asked because I want to change my L.E.D.'s to blue and they said as long as there are NO stickers that say VOID IF SEAL BROKEN and that you don't cause any visable damage (you know what you are doing) then you are fine.

http://community.webshots.com/myphot... curity=QXBHmH

N9QGS · 06-28-2006, 01:11 AM

Does anyone know of an easy access point to grab 12 volt power to power my SkiFi XM receiver, Im looking for taping off the wires that power the 12 v power jack on the center console, anyone know what wires these are closer to a point that can be easily reached under the dash, or how to remove the center console so I can tape off it that way and run it back under the dash?

Thanks, Ron

Tankota · 06-28-2006, 01:26 PM

Can't help you yet.. I did find out that just about everything is under the drivers left side kick panel though, but I have yet to figure out which wire is which.. That's where the dealer tapped into everything for the Chapman alarm system option that I didn't want to pay $600 for. They pulled the alarm CPU but all the wirring for it taps in inside that kick panel, one of them has to be acc switched as well as a constant power. If if figure it out I'll post it.

Unless somebody has the wiring diagram with the color codes for the wires out there????

fnkngrv · 06-28-2006, 03:56 PM

Just too new I would think for that to be published....

Bones · 06-28-2006, 04:55 PM

Hey Tankota,

I posted all the wiring color, polarity,what they do and locations under Alarm Install. Just do a search

eight_heads · 06-28-2006, 05:17 PM

crimestopper has a dealer site that list every point to tap into and actually show pictures of most of them :p

Tankota · 06-29-2006, 12:06 AM

Quote:

Originally Posted by Bones

Hey Tankota,

I posted all the wiring color, polarity,what they do and locations under Alarm Install. Just do a search

Found it, Thanks!

06-23-2006, 04:02 PM	#1
punch Drives: 2007 Yaris Sedan "D" package Join Date: May 2006 Location: Barrie, ontario Posts: 852	installed head unit... 2007 yaris sedan ok, enough about the wife, today i installed an Alpine head unit, using the 2006 echo install kit, and toyota wire kit.. the echo kit was an AI kit, and basically the only part used was the plastic plate and bin, the mounting brakets in the kit DO NOT work, i had to mount the head unit to the stock toyota brakets. the plastic plate fits 'sorta" will be looking for another solution when a yaris specific kit comes out. will post a dash shot later.

06-26-2006, 10:09 PM	#9
eight_heads Drives: '07 Yaris Liftback Join Date: May 2006 Location: LA, USA Posts: 244	does anyone know if changing the stock radio voids any electronic warranty? __________________ '07 Yaris Liftback -Red 5spd w/convenience

06-28-2006, 01:11 AM	#12
N9QGS View User's Garage Drives: 2007 Toyota Yaris Sedan Join Date: Jun 2006 Location: Georgetown, KY Posts: 117	switch powering to power Satellite receiver? Does anyone know of an easy access point to grab 12 volt power to power my SkiFi XM receiver, Im looking for taping off the wires that power the 12 v power jack on the center console, anyone know what wires these are closer to a point that can be easily reached under the dash, or how to remove the center console so I can tape off it that way and run it back under the dash? Thanks, Ron

06-28-2006, 03:56 PM	#14
fnkngrv Mr. 155 and climbing View User's Garage Drives: Seriously Modded 07 Sedan Join Date: Jun 2006 Location: In The Hotbox Posts: 4,742	Just too new I would think for that to be published.... __________________ Team Tiamat Racing on Facebook Youtube Channel: Team Tiamat Racing *Class record holder in Land Speed @ 154.5mph for 1.5 mile and 145.5mph in the mile in the F (2.016 to 3.014 L), G (1.524 to 2.015 L), and H (1.016 to 1.523 L) classes.*

06-28-2006, 05:17 PM	#16
eight_heads Drives: '07 Yaris Liftback Join Date: May 2006 Location: LA, USA Posts: 244	crimestopper has a dealer site that list every point to tap into and actually show pictures of most of them :p __________________ '07 Yaris Liftback -Red 5spd w/convenience

06-23-2006, 06:37 PM	#2
yarislover BUY ONE DON'T STARE Drives: 07yaris liftback Join Date: Jun 2006 Location: burlington,on Posts: 19	I used the same kit what a pain. I used the original mounting bracket,grinded off the points that stick out on the side. You need to use the mounting bracket that comes with the kit to secure the trim. I cut 75% of the plastic and screwed it to the side along with the original bracket. It looks great and is secure but a little work to make it fit perfect. I will post pics when I have everything apart to run my amp cables.

06-24-2006, 09:03 AM	#3
Toddhata Drives: 07 Yaris Liftback, 00 Boxster Join Date: May 2006 Location: Anaheim, CA Posts: 66	After reading your comments on using a kit, I was thinking of buying either the Kenwood or Pioneer 1 DIN graphic equalizer. That way I could use the factory mounting bracket for both the Alpine head unit with the EQ below. Do you guys think that would be a lot easier than trying to get the kit to fit properly?

06-24-2006, 11:06 PM	#4
yarislover BUY ONE DON'T STARE Drives: 07yaris liftback Join Date: Jun 2006 Location: burlington,on Posts: 19	That should work. You may have to watch for gap but all said and done it should fit. If it works out for you I would like to see some pics. I will take a pic tommorow and post it so you can see the finish. It does look good with the trim kit but if you have the EQ go with it, way nicer if it fits.

06-25-2006, 04:17 AM	#5
punch Drives: 2007 Yaris Sedan "D" package Join Date: May 2006 Location: Barrie, ontario Posts: 852	thats not going to work, you still need a trim kit...

06-25-2006, 03:02 PM	#6
yarislover BUY ONE DON'T STARE Drives: 07yaris liftback Join Date: Jun 2006 Location: burlington,on Posts: 19	your right you will need the trim kit unless you make a face plate

06-25-2006, 03:29 PM	#7
yarislover BUY ONE DON'T STARE Drives: 07yaris liftback Join Date: Jun 2006 Location: burlington,on Posts: 19	here are some pics http://community.webshots.com/photo/...93381954mNFpIU http://community.webshots.com/photo/...93381954WcPjrB http://community.webshots.com/photo/...93381954lmSHUB There are more pics of my car at http://community.webshots.com/myphot...ecurity=QXBHmH

06-26-2006, 12:52 PM	#8
Toddhata Drives: 07 Yaris Liftback, 00 Boxster Join Date: May 2006 Location: Anaheim, CA Posts: 66	ok, thanks for the info. I have a kit, just waiting for my eq and head unit to come in. I'll post pics when it's all finished.

06-26-2006, 11:34 PM	#10
mikeukrainetz View User's Garage Drives: 2006 Toyota Yaris Join Date: May 2006 Location: Canada Posts: 564	I installed my new deck before my first oil change, took it in and they didnt say a thing... dont know if they just didnt notice or what (cant miss the LED). I assume if you dont cut into any wires you dont have a problem.

06-27-2006, 06:51 AM	#11
yarislover BUY ONE DON'T STARE Drives: 07yaris liftback Join Date: Jun 2006 Location: burlington,on Posts: 19	I asked because I want to change my L.E.D.'s to blue and they said as long as there are NO stickers that say VOID IF SEAL BROKEN and that you don't cause any visable damage (you know what you are doing) then you are fine. http://community.webshots.com/myphot... curity=QXBHmH

06-28-2006, 01:26 PM	#13
Tankota Prototype Tester Drives: Yaris S-Sedan / FJ Cruiser Join Date: May 2006 Location: Reseda, CA Posts: 67	Can't help you yet.. I did find out that just about everything is under the drivers left side kick panel though, but I have yet to figure out which wire is which.. That's where the dealer tapped into everything for the Chapman alarm system option that I didn't want to pay $600 for. They pulled the alarm CPU but all the wirring for it taps in inside that kick panel, one of them has to be acc switched as well as a constant power. If if figure it out I'll post it. Unless somebody has the wiring diagram with the color codes for the wires out there????

06-28-2006, 04:55 PM	#15
Bones Drives: 07 Yaris S Type Join Date: May 2006 Location: San Diego Posts: 42	Hey Tankota, I posted all the wiring color, polarity,what they do and locations under Alarm Install. Just do a search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Satellite Radio	ToyotaTim	In Car Entertainment + Electronics (audio / video / alarm)	38	03-13-2007 05:37 AM
anyone installed a computer n touch screen yet?	Blenjar	In Car Entertainment + Electronics (audio / video / alarm)	0	06-12-2006 10:06 AM
human head in coffee beans	wushumasterku	Off-topic / Other Cars / Everything else Discussions	8	04-19-2006 11:39 PM