My 2zrfe swap

[brushforhire]

So I finally got the speed signal from the ABS module figured out. It really ended up being stick the wire in the hole, test drive, rinse and repeat, until I got it.

So I am using this as my speed signal and will remove the rest of the speed sensor wiring from the stock tranny. I will use the power supply to the sensor to power the MAF sensor instead of using the add-a-circuit.

More so just being anal about my wiring.

Here are pics of where I ended getting the signal from. It is the white wire, fourth from the left, in the top row, including the two bigger wires.
abs connector.jpg
I simply cut the pink speed signal wire, and spiced the wire to it going into the fuse box.
wires.jpg

I already added this info to the sticky, so future swaps using any trans other than the stock ones that have the speed sensor, can steal the signal from the ABS module, or just redo wiring for cleaning up the engine bay purposes.

I also double checked the speed on the gauge against my GPS unit, and they were almost exact. So both are way off, or both are dead on.