Disable your seat belt alarm (on/off switch)*

[vodkalush]

What for:
If you want to disable your seatbelt alarm. I tend to do alot of work on/in my car and I hate the alarm when I turn the car on. So I wanted away to temp disable the alarm.

Tools Needed:
- Wire strippers/wire cutters
- Drill bit (1/4inch)
- Drill
- Elec. tape (or shrink wrap)
- 10mm socket (for removing center console)

You need to buy/have:
- switch (on/off) ($1 - $15 depends on your taste, mine was $3)
- 2.2k ohm resisters ( $0.99 radioshack) (thanks -*03Z33)

How you do it:

1. I removed the center console (check the service manual)
2. On the center side of your seat there is a small rubber "hose" with the seat-belt wire
3. Cut away some of the rubber hose, and expose the wire's
4. Seperate the wire into "2" then strip a bit of each (you could prob remove the seat and then tap into the wire alot easier... but taking the seat out sounds like a bitch)
5. Use a piece of wire (about 7inches) and attach the wire's together
6. I put a 2.2k ohm resister "in-line" on one side of the wire
7. Hook up the wire to a switch (i used a push-pull on off switch)
8. Tape all your splices (I would recommend you to use heat shrink)
9. Test, TEst, Test
10. I chose a location on my center console that was accessable but hidden (under my e-brake handle)
11. Drill hole, put switch in hole/place
12 . Put everything back together
13. Enjoy your new found ability of control over that 12sec chime....
*