|
02-13-2014, 04:06 PM | #1 |
1 Liter Bottle/Cup Holder
I recently purchased an '09 Liftback, and so far I'm really enjoying it. However, one thing that has bothered me since day 1 is how small all the cup holders are. I usually drink out of 1 Liter bottles and cups, and it was a pain trying to figure out where to put them.
Well, one day I came across this on ebay: Foldable Black Drink Holder I knew exactly where to put it that would give me easy access to my drink, be somewhat out of the way of things, and would cover up some velcro that the previous owner had glued to the piece where I knew would be the perfect spot for this drink holder. I've had it for about a month now, and it is holding up very well. It holds my drinks well, and I can fold it up when not in use. I'd imagine if you don't want to drill into the plastic panel, you could instead mount the cup holder with industrial strength tape. I couldn't get the velcro off that is behind mine that the previous owner had glued to the plastic piece, so I didn't mind drilling a few screws into it. I know it will be secure too. I suppose I also could have just attached velcro to the cup holder and simply used that with the velcro that was already on the plastic panel. I didn't know how well that would hold, so I decided to just put a few screws in. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Phone holder mount | arose62 | Cosmetic Modifications (Exterior/Interior) | 0 | 06-22-2013 09:19 PM |
Loose Change holder(?) and cup holder | nemobile | Cosmetic Modifications (Exterior/Interior) | 14 | 02-21-2012 09:56 PM |
Will Changing the Pod from a 1.5 Liter Vitz with rev counter to a 1.0 Liter Vitz | anthpace | Cosmetic Modifications (Exterior/Interior) | 4 | 11-09-2011 01:52 PM |
Dash Cup Holder | dzcab | Cosmetic Modifications (Exterior/Interior) | 5 | 08-17-2011 10:24 PM |
Install Oil Pressure, Voltage and Temperature Gauges with DIY Holder | bieniman | DIY / Maintenance / Service | 4 | 05-19-2009 11:40 PM |