Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 05-08-2019, 12:17 PM   #1
jayis
 
Drives: 2008 Toyota Yaris
Join Date: Feb 2019
Location: Detroit, MI
Posts: 8
Leaking From Above A Pillar

Anyone had any problem with leaks above the A pillar? I think it's from underneath where the "drip moulding" is supposed to clip to. That wasn't my first guess, I put silicone windshield repair between the windshield and the car but that didn't stop the leak. I removed the roof liner to get a better look at it. I plan to just pour silicone on everything that I can to get it to stop. It drips on my leg and it is pretty annoying. Any ideas?

In the pics there is some water still there from testing it.
Attached Images
File Type: jpg 1.jpg (230.3 KB, 86 views)
File Type: jpg 2.jpg (488.8 KB, 86 views)
File Type: jpg 3.jpg (290.8 KB, 86 views)
jayis is offline   Reply With Quote
Old 05-08-2019, 02:13 PM   #2
Mike Dexter
 
Drives: '10 Hatchback
Join Date: Dec 2016
Location: Ontario
Posts: 9
See the crack in the paint just behind the clip? That crack likely goes through the sealer that covers the welded joint at the roof edges.

Get a tube of body sealer from an auto parts store, and brush it all over the bottom of the trench. Silicone dries and cracks over time...found that out the hard way.

I can't tell from your 3rd photo - does that large circular hole allow you to get at the clip's bolt/nut from the underside? If you can, remove that clip, and seal under it too. If not, reach through and brush sealer from underneath.
Mike Dexter is offline   Reply With Quote
Old 05-08-2019, 03:43 PM   #3
dogsridewith
 
Drives: 2007 2-door hatchback
Join Date: Jul 2016
Location: USAnotCA
Posts: 745
Running w/o gutter strips. Noticed and probed-to-confirm-clear what I interpreted to be a deliberate drain hole into the top of the A-pillar. Hole is near the corner of the glass.
dogsridewith is offline   Reply With Quote
Old 05-10-2019, 12:53 AM   #4
GibbsYaris07
 
Drives: 2007 Toyota Yaris 3dr
Join Date: Aug 2017
Location: Charlotte, NC
Posts: 57
I have the same exact issue. I will pull out the molding an apply the black body sealer as well.
__________________
The Gibbs Garage
2014 Lexus IS350 f-sport (my fun car)
2013 Lexus RX350 (wife's vehicle)

2007 Toyota Yaris 2dr Hatchback (my commuter)
GibbsYaris07 is offline   Reply With Quote
Old 05-27-2019, 08:34 AM   #5
ct77414
 
Drives: 2007 Yaris Coupe
Join Date: Aug 2016
Location: Texas
Posts: 2
Quote:
Originally Posted by GibbsYaris07 View Post
I have the same exact issue. I will pull out the molding an apply the black body sealer as well.
My Molding Strips things recently began peeling off.
Kind of obvious problem at 70 MPH and something slapping the back of the car. I ripped them off and now I've got tiny leak at A Pillar just above me, The Driver. I'm going to look into this Body Filler Stuff.
I was just going to silicone over the holes that cannot be seen until I get it properly fixed.

I guess "Body Filler" IS Bondo?
That would not be the thing to do if one ever wanted to fix it Right. Body Man.....OK. DIY...No.
I guess what is Right to some is different for others.

Last edited by ct77414; 05-27-2019 at 08:48 AM.
ct77414 is offline   Reply With Quote
Old 06-12-2019, 09:15 PM   #6
jayis
 
Drives: 2008 Toyota Yaris
Join Date: Feb 2019
Location: Detroit, MI
Posts: 8
Quote:
Originally Posted by Mike Dexter View Post
I can't tell from your 3rd photo - does that large circular hole allow you to get at the clip's bolt/nut from the underside?
I looked with a light and stuck my fingers everywhere and couldn't see or feel anything like a bolt holding the clip in place. I actually think it might be welded there?

I wanted to test covering potential points where the water is leaking in with the silicone I had before I went ahead and got seam sealer, removed the silicone, and really covered things in a durable way. I covered everything up that looked like a crack in the gutter and the leak didn't go away. That's when I started looking for other places the water could be coming in. Eventually I put silicone across almost the entire width of the car where the windshield meets the roof. This finally killed the leak...so far. A picture of my terrible handiwork is attached.
Attached Images
File Type: jpg Webp.net-resizeimage (1).jpg (377.9 KB, 41 views)
jayis is offline   Reply With Quote
Old 08-31-2019, 06:59 PM   #7
jayis
 
Drives: 2008 Toyota Yaris
Join Date: Feb 2019
Location: Detroit, MI
Posts: 8
Just want to update this in case this happens to someone else.

Putting silicone between the windshield and the car didn't actually solve the problem, and was probably completely unnecessary.

I had a small crack in the gutter farther up than I thought was possible. Basically at like the highest point of gutter. I sealed it all up with silicone (which Mike Dexter mentioned will fail eventually, I'll get there when I get there) and it finally went away.
jayis is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Leaking rear wheel cylinders? xdarkxfirex DIY / Maintenance / Service 8 04-11-2017 02:47 PM
Chrome pillar trim for 3 dr Foot Cosmetic Modifications (Exterior/Interior) 3 01-26-2013 05:09 PM
Water Leaking into car! CKaelin General Yaris / Vitz Discussion 18 08-16-2012 01:53 AM
Axle seals leaking caused by lowering ride height? NH3R717 DIY / Maintenance / Service 2 07-22-2010 03:29 PM
Fishing an AV wire down B pillar redyaris In Car Entertainment + Electronics (audio / video / alarm) 6 03-10-2007 07:17 PM


All times are GMT -4. The time now is 08:13 AM.




YarisWorld
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.