 |
 |
|
|
05-29-2018, 08:26 AM
|
#1 |
 Drives: 2007 Yaris Hatchback Join Date: Sep 2011
Location: Halifax NS
Posts: 11
|
Could penetrating oil damage AF sensor?
I replaced the fwd donut gasket yesterday.
Noise is gone and now I have multiple different codes for Bank 1 Sensor 1. I metered out the sensor as per manual and the sensor is shorted between pin 1 and 2 and open between 1 and 4. The exhaust stinks badly when engine's running. I had sprayed flange bolts prior to replacement for a few days and I got some penetrating oil (Seafoam deep creep) on AF sensor by accident while I was spraying LH bolt from top. The car has 130,000km (81,000 miles) and the sensor is original. A Denso 234-9052 is on its way from Rockauto. Did anyone have the similar issues before? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Used Oil Analysis - Yaris '08 144,000km | tmontague | DIY / Maintenance / Service | 10 | 10-30-2015 12:26 PM |
| My Oil Analysis 2007 hb 5 speed 123,994 miles | mark293 | General Yaris / Vitz Discussion | 12 | 02-25-2012 10:19 PM |
| Natural Gas Transportation - Why Not? | Kal-El | Off-topic / Other Cars / Everything else Discussions | 1 | 03-20-2011 01:12 PM |
| Question about a changing oil level | Goose | DIY / Maintenance / Service | 3 | 11-02-2010 10:32 PM |
| Synthetic Oil Questions. | Twistoffate0817 | General Yaris / Vitz Discussion | 19 | 07-15-2009 08:54 PM |
Threaded Mode