|
|
|
Thread Tools | Display Modes |
05-01-2013, 03:14 AM | #1 |
Drives: 2012 Yaris SE Join Date: Mar 2013
Location: SoCal
Posts: 30
|
Not sure what section .. So question on fog light housing that was .... *PICS*
Busted by a large truck kicking up a sizable piece of rubber and launching it at my little yaris. Damage luckily was only the housing and some rubber marks on the bumper. I pulled out the fog light cover and fog light itself. I'm trying to figure out what plastic it is made of so I can glue the tabs back on and mount it back up. Good thing the light still works. Sucks going from a 4x4 truck to a tiny car with road debris all over SoCal
My first run in with a chuck of metal I couldn't avoid! Hole in my gas tank a month ago!! |
05-01-2013, 06:23 AM | #2 |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
The PBT on the back says that it is Polybutylene terephthalate.
__________________
|
05-01-2013, 07:19 AM | #3 |
Drives: 2012 Yaris SE Join Date: Mar 2013
Location: SoCal
Posts: 30
|
|
05-01-2013, 07:46 AM | #4 |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
The most effective adhesive I have found for plastics like this is Plexus MA310:
http://www.jamestowndistributors.com...ct.do?pid=4882
__________________
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How many forum posters does it take to change a light bulb? | silver_echo | Off-topic / Other Cars / Everything else Discussions | 25 | 06-27-2011 01:50 AM |
WTB: Fog Light Switch or Stalk | Lil Abner | Willing to Buy by private party | 4 | 08-20-2010 08:07 AM |
Fog Light Misalignment and Moisture | DjT | General Yaris / Vitz Discussion | 3 | 04-27-2009 03:24 PM |
question on Fog light | clfile | Cosmetic Modifications (Exterior/Interior) | 6 | 11-09-2006 07:11 PM |
rear fog light and tuned rear lights | lefti696 | Cosmetic Modifications (Exterior/Interior) | 0 | 11-09-2006 03:06 PM |