 |
 |
|
|
12-26-2015, 04:01 PM
|
#1 |
|
Mr. 155 and climbing
Drives: Seriously Modded 07 Sedan Join Date: Jun 2006
Location: In The Hotbox
Posts: 4,742
|
DIY tool for fuel tank lid
There has been more discussion as of late about fuel pump and regulator access so here are a few photos of the DIY tank lid tool I made. 1" steel pipe. We cut a 3" section off of the length of pipe I bought and then sliced it down the middle to make two half moon sections. I then welded them as you can see so that they will grip the teeth built into the lid. The length of the bar is 30" to give plenty of ability for torque to remove/reinstall. I have used it probably well over a dozen times with no issues. Hope this helps people. This is a much cheaper alternative to the Toyota tool that costs hundreds of dollars.
    Sent from my XT1575 using Tapatalk
__________________
Team Tiamat Racing on Facebook Youtube Channel: Team Tiamat Racing Class record holder in Land Speed @ 154.5mph for 1.5 mile and 145.5mph in the mile in the F (2.016 to 3.014 L), G (1.524 to 2.015 L), and H (1.016 to 1.523 L) classes. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: 60/40 Split Seat Install (some welding required) | CTScott | DIY / Maintenance / Service | 13 | 03-05-2017 04:12 PM |
| DIY - Removing the gas tank from under the car (to access the fuel filter, etc.) | CTScott | DIY / Maintenance / Service | 1 | 08-21-2013 03:57 PM |
| tool list | silver_echo | Off-topic / Other Cars / Everything else Discussions | 5 | 10-21-2010 10:23 PM |
Threaded Mode