rotrex supercharger

[eTiMaGo]

Originally Posted by cdydjded

Carvin: Bending pipes is the least of you worries. Read my previous post, our engines pulley system is not enough to support the Rotrex pully requierments. Why are you speculating or guesing if the Rotrex will work?

Originally Posted by Carvin'07

You could have a pulled milled from stock aluminum, but that will cost you big bucks. You might want to try out an xA or xB (??) pulley, I can't remember which was mentioned earlier to see if it will fit our needs.

Basically, our Yarii use a single pulley system while the xA/xB use a double pulley, hence it may be possible to use the extra pulley groove to run the supercharger. But the best bet would still be a custom-made one.