|
01-08-2014, 10:59 PM | #1 |
Drives: toyota echo Join Date: Jun 2013
Location: Canada
Posts: 21
|
fidanza flywheel
I just receve my fidanza flywheel an will install it soon.
does some body has some tips? what to do or not to do? when installing it I have a 2005 toyota echo. |
01-09-2014, 08:00 PM | #2 |
Drives: 2005 Toyota Echo Join Date: Aug 2010
Location: Brampton, ON
Posts: 505
|
-Install a new clutch at the same time
-Get new flywheel and pressure plate bolts -Definietely get a load leveler for your engine hoist -You may need to unbolt the subframe a bit to give you enough clearance to slide the tranny out of the way -You probably won't have to, but getting the axles out of the tranny is a huge pain
__________________
2006 Saturn Ion Redline 2005 Toyota Echo RS 4dr hatch - Cyl #3 bad - sold 2000 Toyota Echo 2dr coupe - The track car - rusty & scrapped |
05-02-2014, 05:14 PM | #3 |
Drives: toyota echo Join Date: Jun 2013
Location: Canada
Posts: 21
|
do you think a transmission jack can replace the engine hoist?
and is it really necessary to unbolt the subframe? because where I will be to work on this I will have 1-2 friends and more then 1 transmission jack |
05-13-2014, 06:30 PM | #4 |
Drives: toyota echo Join Date: Jun 2013
Location: Canada
Posts: 21
|
bump
|
05-13-2014, 08:04 PM | #5 |
Takes corners too fast!
Drives: Absolute Red 2009 Yaris HB Join Date: Apr 2012
Location: Columbia, SC
Posts: 830
|
i pulled the power train to change my flywheel and clutch. makes the flywheel and clutch part easier.
__________________
mods:15''Drag DR21 w/Nitto NeoGen 205/50R15, Tanabe DF210 lowering springs 1.6/1.8, TRD Rear Sway Bar, Tanabe Front Sway Bar, Micro Image Short Throw Shift Kit (both in and under), 8.64lbs flywheel, F1 Stage 4 Clutch, AEM Cold Air Intake (Red), Megan Racing Header, DC Sports Axle Back Exhaust, Micro Image Crank Pulley, NST lite Alternator Pulley, ARP Manifold Stud Kit,Tanabe Front Strut Tower Brace, ScanGuage II, Micro Image Silicone Radiator Hose Kit (Red), NRG Carbon Fiber Shift Knob (round), 2009-2011 Toyota Yaris Liftback Foglight kit, NRG Grounding Kit (Red), Hella Horns(Red),CF Hood |
05-15-2014, 04:00 PM | #6 |
Drives: 2005 Echo Rs Join Date: Sep 2010
Location: Beaverton ON
Posts: 48
|
I put in a fidanza flywheel in my echo this winter.
Replace the clutch housing, clutch and throw-out bearing. I pulled the drive shafts ; not that hard when you figure out where to pry from. I had to lower the sub-frame; I tried, but couldn't find a way around that. I used a cut up office chair and car jack as my transmission jack. Not ideal but it worked. I used the front strut bar and garage rafters as an engine hoist. Again crude, but it worked. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch install & flywheel questions So Cal | xb visitor | Performance Modifications | 3 | 11-04-2013 10:43 AM |
Questions for new flywheel and clutch | mrbond | Performance Modifications | 11 | 07-11-2013 07:17 AM |
Flywheel question-1nz conversion-2003 Model | Echo56 | DIY / Maintenance / Service | 0 | 05-21-2013 10:42 PM |
Cp Pistons, Pauter rods , greddy, fidanza and other for 1NZ-FE!!! | Giupo | Items for Sale by private party | 11 | 08-25-2009 02:57 PM |
lightweight flywheel from fidanza | dngz | Performance Modifications | 34 | 02-03-2009 11:02 PM |