OFFICIAL Yaris SEDAN thread

[RHDVIPbB]

hey camelll, where did you get the trunk lip spoiler?

[jpadua]

Originally Posted by camelll

They are done!

Very nice camell! looks good with the eyelids

[jpadua]

Originally Posted by camelll

Thanks jpadua, if these are the same projectors you have in the philippines then you should get a set if you don't already have them.

Oh a bunch of projectors are coming in... not bixenon, but more like the projectors in the US for ScionTC, with 1 projector for low beam, one high beam, ccfl rings and Leds for park lights. Thats going to look bad ass.. I'll post it up once I get a photo.

[LEGATO``]

Originally Posted by jpadua

Oh a bunch of projectors are coming in... not bixenon, but more like the projectors in the US for ScionTC, with 1 projector for low beam, one high beam, ccfl rings and Leds for park lights. Thats going to look bad ass.. I'll post it up once I get a photo.

daaaaaammnnnn
i should of brought my headlights and go them done when i was there a month ago hah

[jpadua]

Originally Posted by camelll

They gonna be like the depo lights? That would require a little bit of wiring trickery as well cause we only use 1 bulb for hi/low. I know for sure it can be done but you will have to figure out which wire/wires control high beams and they you will have to make a harness. Still cannot wait to see them though.

Yeah, thats true, wiring has to be re done in some way, definately not a plug and play thing, not unless the headlight assemblies come with them. These projectors are already housed in headlight assemblies so you replace the whole headlight.

[jpadua]

Originally Posted by camelll

The Projectors I just bought came in factory jdm housing and the usdm plugs on the harness for the parking and turn signal bulbs did not fit so I had to take apart the jdm housings pull the projectors and put them in my usdm housing, but the jdm headlights did not come with the harness that plugs into those spots so might have been a different outcome if they did. Are the ones you getting come with that or a harness for these bulbs?

I havent really seen them yet, but I should have photos by next week. If ever, there might be some wiring that has to be done to make them work, but the housings should fit thought :)

[smofskra]

Originally Posted by camelll

Looking good tristan, could you take a pic of the of the whole rear, not so close up? I think they look better painted than not.

Thank you very much. Here is a pic of the whole rear. I really need to repaint the emblem and the trim piece above the license plate. It's bothering me more and more every time I look at it.

[Kal-El]

Nice Camelll.

Hey, are those headlights custom painted or did you buy them like that? I know they're aftermarket projectors but just wondering about the black bezels. I want them!!! They look great.

[JumpmanYaris]

I ll buy ur pillar