Cruise control on 2007 4dr - Page 2 - Toyota Yaris Forums

Fazulka · 01-17-2010, 01:49 PM

Wow, I can't believe I put it in the wrong one. It works great now!

Oh, well, hopefully this thread will help anyone that wants to install it.

For anyone trying, there are several pictures besides the incorrect one above that you can look at. Just to describe the current location to anyone else it is the second one in from the passenger side edge of the connector, on the front/engine side of the little valley. It is right next to a blue wire.

Prices were:

$ .99 x 4 packages of resistors. Although 3 should have been fine, see above.
$2.49 x 2 for red switches
$2.69 x 2 for black switches
I bought 75 feet of wire, but not just for this project. I think it was $6.49
2 wire nuts (not required) i already had, but cheap
zip ties. I had them but cheap to buy.
Electrical tape (already had)
Solder (already had)

Total time was a 2-3 hrs. Would have been 30 minutes if I could figure out what I did wrong.

Thank you CTScott!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag	CTScott	DIY / Maintenance / Service	307	04-04-2023 03:43 AM
Cruise Control - Again!	CB900F2	DIY / Maintenance / Service	47	06-17-2010 06:29 PM
Cruise control vs MPG	YarisOwnersDad	Fuel Economy Forum	15	05-29-2009 03:55 PM

01-17-2010, 01:49 PM	#19
Fazulka Drives: 2007 Yaris 4dr Sedan Base Join Date: Nov 2009 Location: Boston, MA Posts: 18	Wow, I can't believe I put it in the wrong one. It works great now! Oh, well, hopefully this thread will help anyone that wants to install it. For anyone trying, there are several pictures besides the incorrect one above that you can look at. Just to describe the current location to anyone else it is the second one in from the passenger side edge of the connector, on the front/engine side of the little valley. It is right next to a blue wire. Prices were: $ .99 x 4 packages of resistors. Although 3 should have been fine, see above. $2.49 x 2 for red switches $2.69 x 2 for black switches I bought 75 feet of wire, but not just for this project. I think it was $6.49 2 wire nuts (not required) i already had, but cheap zip ties. I had them but cheap to buy. Electrical tape (already had) Solder (already had) Total time was a 2-3 hrs. Would have been 30 minutes if I could figure out what I did wrong. Thank you CTScott!