Making a engine wiring harness

[maxthehax]

Hey guys, I would like to purchase a aem EMS standalone and Im planning to make a fresh new harness for it.

There are some OEM sensors that I will keep to run the engine, by exemple;
-Crank position sensor
-Cam position sensor
-VVTI solenoid
-PWM on the TB
-TPS on the TB

I have all the sensors, all I need are 2 pieces;

The plastic clip that hook up directly to those sensors and the little metal connector that crimp to your wire and slip into the plastic connector.

I don't want any solder, I want a fresh new harness just like a OEM one.

Where can I find those connectors?

Here is a nice website I found but it doesnt say much about the connectors and they mostly look all the same...
http://www.automotivewiringsystems.c...6-products.htm