Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 07-20-2013, 06:52 PM   #163
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Thank you so much CTScott,
My 2007 auto transmission Yaris is a 5 door hatch back without keyless entry, manual windows, but have a button to lock and unlock the door. Does it need a keypass or not?
Thank you again,
WestCoast is offline   Reply With Quote
Old 07-20-2013, 08:56 PM   #164
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Thank you so much CTScott,
My 2007 auto transmission Yaris is a 5 door hatch back without keyless entry, manual windows, but have a button to lock and unlock the door. Does it need a keypass or not?
Thank you again,
Most likely not with an 07, but you can tell by looking at the ignition switch. If it is all metal then no, if the part that rotates is metal and the part that surrounds it is black plastic, then yes.
__________________
CTScott is offline   Reply With Quote
Old 07-21-2013, 02:53 AM   #165
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Thank you so much for your reply so quickly. My ignition switch doesn't have the black plastic surround it. So should be don't need the keypass.
My remote starter is Firstech CM6200. I connected the CN1(Accessory, Starter, Ignition, Ground, Constant 12V, 12 Parklning light output), and CN4(Unlock Output, Lock Output).
But didn't connect the CN2, which are (Output to Starter-kill), Hood Pin Input, .... etc.)
Because I don't know where to find these cables in your diy chart. Any advices for me?
WestCoast is offline   Reply With Quote
Old 07-21-2013, 03:12 AM   #166
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Actually, my CN2 details as below:
(-) 250mA Output to Starter-Kill Blue 1
(-) Parking Light Reminder Orange/Black 2
(-) 250mA 2nd Parking Light Output(POC #1) Green/White 3
(-) Emergency Brake Input Light Blue 4
(-) 250mA 2nd Starter Output (POC #2) Red/Black 5
(+) Foot Brake Input Light Blue/White 6
(-) 250mA 2nd Ignition Output (POC #3) Green 7
(-) Trunk Trigger Input Violet/Black 8
(-) 250mA 2nd Accessory Output (POC #4) White/Black 9
(+/-) Door Trigger Input Red/White 10
(-) 250mA Status Out(GWR) (POC #5) Black 11
(+/-) Key Sense/Glow Plug Input Brown/White 12
(-) 250mA Rearm Output (POC #6) Orange 13
(-) Slave/Timer Start input Pink 14
(-) 250mA Disarm Output (POC #7) Orange/White 15
Engine Sensing Input (Alt./Tach/Battery) Yellow/Black 16
(-) 250mA Horn Output (POC #8) White 17
(-) Hood Pin Input Gray/Black 18
(-) 250mA Aux1 Output (POC #9) Violet 19
(+) 12V Output to Siren Brown 20

I only need remote start my car, and remote lock and unlock my car, do I need connect all of these cables or just some of them. It's really hard for me to find the right connecting place.
WestCoast is offline   Reply With Quote
Old 07-21-2013, 06:20 AM   #167
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Starter kill is an optional one that requires an extra relay and is documented in your remote starter's manual. You end up cutting the black starter wires on the ignition switch connector and connecting the relay in between.

Parking light output, foot brake, 2nd Ignition output, and Tach input are all in my guide.

The hood pin will be documented in your manual, as it is simply a pin switch that requires you to drill a hole to mount under the hood. It doesn't get connected to any of the car's wires.
__________________
CTScott is offline   Reply With Quote
Old 07-21-2013, 07:08 PM   #168
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Hi CTScott, I have tested my +12V parking light(green pin 29), but the meter read is 0, and the -12V parking light(white pin 13) is 12V. What I can do?
My CM6200 need input is +12V.
Thanks in advance,
WestCoast is offline   Reply With Quote
Old 07-21-2013, 09:29 PM   #169
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Hi CTScott, I have tested my +12V parking light(green pin 29), but the meter read is 0, and the -12V parking light(white pin 13) is 12V. What I can do?
My CM6200 need input is +12V.
Thanks in advance,
Parking light is not an input, it is an output, so your device will output +12V to pin 29 to flash the lights.
__________________
CTScott is offline   Reply With Quote
Old 07-22-2013, 01:52 PM   #170
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Good to know, and where is the Emergency Brake pin in my 2007 auto transmission yaris?
WestCoast is offline   Reply With Quote
Old 07-22-2013, 02:02 PM   #171
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Good to know, and where is the Emergency Brake pin in my 2007 auto transmission yaris?
The yellow wire at the base of the ebrake lever or the yellow wire in pin 4C-2. The ebrake is typically not required for remote starters, except for with manual trans.
__________________
CTScott is offline   Reply With Quote
Old 07-22-2013, 05:26 PM   #172
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Do my auto trans car still don't need the Door Trigger input for my remote start?
WestCoast is offline   Reply With Quote
Old 07-22-2013, 06:05 PM   #173
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Do my auto trans car still don't need the Door Trigger input for my remote start?
Check the manual for your remote starter. Most do not require that, as they can be used with cars with manual locks.
__________________
CTScott is offline   Reply With Quote
Old 07-22-2013, 06:30 PM   #174
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Where to output my (+) 12V Siren if i my car don't have the arm system?
WestCoast is offline   Reply With Quote
Old 07-22-2013, 08:54 PM   #175
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Where to output my (+) 12V Siren if i my car don't have the arm system?
Unless you are adding a siren you won't need to connect that.
__________________
CTScott is offline   Reply With Quote
Old 07-23-2013, 02:22 AM   #176
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
My CM6200 said I need cut the green loop wire inside the brain module, but I can't find it, where is my green loop wire?
WestCoast is offline   Reply With Quote
Old 07-23-2013, 06:00 AM   #177
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
My CM6200 said I need cut the green loop wire inside the brain module, but I can't find it, where is my green loop wire?
It is inside of the remote starter, not a wire on the car.
__________________
CTScott is offline   Reply With Quote
Old 07-23-2013, 12:20 PM   #178
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).
WestCoast is offline   Reply With Quote
Old 07-23-2013, 01:54 PM   #179
CTScott
ULTIMATE
 
CTScott's Avatar
 
Drives: 09 5dr LB, 2x 08 3dr LB
Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
Quote:
Originally Posted by WestCoast View Post
Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).
I have only installed a remote starter on a Yaris which has the engine immobilizer and therefor required the key bypass module. It sounds like even though yours does not have the immobilizer that the ECM wants to see the "unlock warning switch". It is a 2 pin connector on the ignition switch with a yellow and a white/black wire. As a quick test, just jump the yellow to the white/black by shoving a piece of wire in the back of the connector. If it remote starts with that jumped, then you will need to hook the yellow wire to the start #2 output of the remote starter.
__________________
CTScott is offline   Reply With Quote
Old 07-23-2013, 06:55 PM   #180
WestCoast
 
Drives: yaris
Join Date: Jul 2013
Location: Dawson Creek
Posts: 13
You are the amazing man CTScott, I never done this before, but every thing works great now.
WestCoast is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW VitzBoy General Yaris / Vitz Discussion 7 09-20-2023 07:50 AM
Northeast DIY Remote Start / Keyless Entry Workshop - Sunday, October 26 CTScott General Yaris / Vitz Discussion 51 11-10-2012 01:32 PM
2007 Yaris Pricing Info ! YarisBueller New YARIS Purchase Forum 104 06-24-2009 04:54 PM
yaris sedan remote trunk relase question pls help soon fantabulousbaby New YARIS Purchase Forum 4 08-05-2006 01:26 AM


All times are GMT -4. The time now is 03:59 AM.




YarisWorld
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.