Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 05-08-2019, 12:17 PM   #1
jayis
 
Drives: 2008 Toyota Yaris
Join Date: Feb 2019
Location: Detroit, MI
Posts: 3
Leaking From Above A Pillar

Anyone had any problem with leaks above the A pillar? I think it's from underneath where the "drip moulding" is supposed to clip to. That wasn't my first guess, I put silicone windshield repair between the windshield and the car but that didn't stop the leak. I removed the roof liner to get a better look at it. I plan to just pour silicone on everything that I can to get it to stop. It drips on my leg and it is pretty annoying. Any ideas?

In the pics there is some water still there from testing it.
Attached Images
File Type: jpg 1.jpg (230.3 KB, 29 views)
File Type: jpg 2.jpg (488.8 KB, 29 views)
File Type: jpg 3.jpg (290.8 KB, 29 views)
jayis is offline   Reply With Quote
Old 05-08-2019, 02:13 PM   #2
Mike Dexter
 
Drives: '10 Hatchback
Join Date: Dec 2016
Location: Ontario
Posts: 7
See the crack in the paint just behind the clip? That crack likely goes through the sealer that covers the welded joint at the roof edges.

Get a tube of body sealer from an auto parts store, and brush it all over the bottom of the trench. Silicone dries and cracks over time...found that out the hard way.

I can't tell from your 3rd photo - does that large circular hole allow you to get at the clip's bolt/nut from the underside? If you can, remove that clip, and seal under it too. If not, reach through and brush sealer from underneath.
Mike Dexter is offline   Reply With Quote
Old 05-08-2019, 03:43 PM   #3
dogsridewith
 
Drives: 2007 2-door hatchback
Join Date: Jul 2016
Location: USAnotCA
Posts: 739
Running w/o gutter strips. Noticed and probed-to-confirm-clear what I interpreted to be a deliberate drain hole into the top of the A-pillar. Hole is near the corner of the glass.
dogsridewith is offline   Reply With Quote
Old 05-10-2019, 12:53 AM   #4
GibbsYaris07
 
Drives: 2007 Toyota Yaris 3dr
Join Date: Aug 2017
Location: Charlotte, NC
Posts: 57
I have the same exact issue. I will pull out the molding an apply the black body sealer as well.
__________________
The Gibbs Garage
2014 Lexus IS350 f-sport (my fun car)
2013 Lexus RX350 (wife's vehicle)

2007 Toyota Yaris 2dr Hatchback (my commuter)
GibbsYaris07 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Leaking rear wheel cylinders? xdarkxfirex DIY / Maintenance / Service 8 04-11-2017 02:47 PM
Chrome pillar trim for 3 dr Foot Cosmetic Modifications (Exterior/Interior) 3 01-26-2013 05:09 PM
Water Leaking into car! CKaelin General Yaris / Vitz Discussion 18 08-16-2012 01:53 AM
Axle seals leaking caused by lowering ride height? NH3R717 DIY / Maintenance / Service 2 07-22-2010 03:29 PM
Fishing an AV wire down B pillar redyaris In Car Entertainment + Electronics (audio / video / alarm) 6 03-10-2007 07:17 PM


All times are GMT -4. The time now is 11:41 AM.




YarisWorld
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.